Quick answer: Wiper Blade Replacement on a 2013–2022 Acura ILX is rated Easy and takes about 10–15 minutes. You'll need 1 tool for this job, and parts cost about $66. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| Driver wiper blade, 26" |
Bosch 26A |
$32.99 |
|
| Passenger wiper blade, 19" |
Bosch 19B |
$32.99 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm your sizes and buy the right blades
The Acura ILX ran one generation from 2013 to 2022 — it's Civic-based, and Acura never changed the wiper fitment in all ten years, facelifts included. The driver side is 26 inches, no debate. The passenger side is where you need to pay attention: most charts list 19 inches, but a couple of big vendors list 18. Measure your old passenger blade end to end before you buy — one inch of guesswork leaves either an un-wiped strip or an overhanging tip. Both fronts use a standard 9x3 J-hook arm, so any quality 26- and 19-inch (or measured 18-inch) J-hook blades work. The ILX is a sedan with no rear wiper, so it's a two-blade job.
🔧 Mechanic's note — Tom Becker
I've done this job enough times to say it plain: Measure your old passenger blade end to end before you buy — one inch of guesswork leaves either an un-wiped strip or an overhanging tip.
2
Park the wipers and get set up
Switch the wipers off and shut the car down so the arms rest at the base of the windshield. Tuck a folded towel under each arm on the cowl as cheap insurance against a slipped arm.
🔧 Mechanic's note — Ray Delgado
I've learned this one the hard way — if the car has been sitting in freezing weather, make sure the blades aren't iced to the glass before you lift; run the defroster a few minutes rather than peeling them free.
3
Remove the old driver-side blade
Lift the driver-side arm until it stands away from the glass on its own. Press the tab and slide the blade down off the open end of the hook — it's a short slide, an inch or two, and then the blade is free.
4
Prep the new blade
Open up one new 26-inch blade and hold it against the old driver blade to confirm the length matches end to end. Pull off the plastic guard covering the rubber edge — new blades always ship with one, and it's the number-one reason fresh blades streak on day one. Check the center fitting is the 9x3 J-hook saddle; if your blades came with extra adapters in the box, you won't need them for the ILX, so set them aside. Wipe the windshield along the blade's path with glass cleaner while the arm is up — the ILX's long 26-inch sweep collects a lot of road film.
5
Install the new driver blade and confirm the lock
Thread the arm's hook tip through the new blade's saddle, then draw the blade back along the arm until the hook seats home and the locking tab clicks. Ease the arm back down to the windshield slowly, keeping your grip on it the entire way; a bare arm released from upright can crack the glass. Look along the blade to confirm it sits flat for its full 26 inches with no bowed sections.
🔧 Mechanic's note — Tom Becker
Shop habit of mine: Ease the arm back down to the windshield slowly, keeping your grip on it the entire way; a bare arm released from upright can crack the glass.
6
Do the passenger side — no rear blade on this car
Repeat the tab-press-and-slide on the passenger arm with the shorter blade — the 19-inch (or 18-inch, whichever you measured). The ILX sedan has no rear wiper, so there's nothing else to buy or change.
7
Test with washer fluid
Watch the long driver blade especially: it should clear its arc without lifting at speed or squealing at the reversal points, and neither blade should touch the pillar trim or the cowl.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Guessing on the passenger blade — charts split 18 vs 19 inches, so measure the old one.
- • Putting the 26-inch blade on the passenger side — it will hit the A-pillar trim.
- • Buying a rear blade for an ILX — the sedan has no rear wiper.