Quick answer: Wiper Blade Replacement on a 2017–2021 Acura MDX is rated Easy and takes about 10–15 minutes. You'll need 1 tool for this job, and parts cost about $81. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| Driver wiper blade, 26" |
Bosch 26A |
$32.99 |
|
| Passenger wiper blade, 20" |
Bosch 20B |
$32.99 |
|
| Rear wiper blade, 14" |
— |
$14.99 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm your sizes and buy the right blades
This covers the 2017–2021 MDX (third generation plus the 2021 carryover): 26 inches driver, 20 inches passenger, 14 inches rear — steady across the whole range, including the Sport Hybrid. Confirm your MDX is a 2017–2021 and buy 26/20/14.
2
Set the wipers to the maintenance position
The MDX parks its arms tucked under the hood's trailing edge, so don't muscle them up by hand. Honda's own guidance warns that yanking the arms up manually can damage the wiper linkage.
🔧 Mechanic's note — Tom Becker
Same maintenance-position trick as the RDX — tucked arms and a manual that warns against hand-lifting. Off, hold MIST, ON, back to OFF. I set the arms mid-windshield before I even open the blade boxes.
3
Remove the old driver-side blade
Lift the driver-side arm off the glass. Find the locking tab on the holder where it meets the J-hook tip; press up on the tab and slide the holder off the arm.
4
Prep the new blade
Open the new 26-inch blade and lay it alongside the old driver blade to verify the length. Confirm the center connector is the J-hook saddle with a locking tab; fit the J-hook adapter now if your blades came with options.
5
Install the new driver blade and verify the lock
Slide the new blade's holder onto the arm until the locking tab clicks home. Ease the arm back down slowly, keeping your hand on it all the way. Eyeball the full 26 inches against the glass — lifted ends leave un-wiped arcs in your sightline.
6
Do the passenger side, then the rear blade
Still in the maintenance position, repeat the tab-and-slide swap on the passenger arm with the 20-inch blade. Don't fit the 21-inch blade from previous-generation charts — it overhangs the cowl. Don't skip the rear blade — that back glass gets filthy fast.
🔧 Mechanic's note — Ray Delgado
The 21-inch passenger blade is the old MDX's number and it overhangs the cowl on this car — I've learned generation traps are how you buy blades that technically click in and still don't work.
7
Re-park the arms and test with washer fluid
Spray washer fluid and run the fronts through intermittent, low, and high — silent, full even coverage, no clashing at the center. Run the rear washer and wiper and check the 14-inch blade clears the liftgate.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Buying 26/21/12 blades from charts showing the 2007–2013 MDX — the 2017–2021 takes 26/20/14.
- • Forcing the tucked arms up by hand instead of using the MIST maintenance-position sequence.
- • Fitting the 21-inch previous-gen passenger blade, which overhangs the cowl.