← Back to Acura RSX Guides

2002–2006 Acura RSX

2002-2006 Acura RSX — Battery Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 30-90 minutes $180 DIY

Save $120 by doing it yourself! Shop cost: $300

Quick answer: Battery Replacement on a 2002–2006 Acura RSX is rated Easy and takes about 30-90 minutes. You'll need 2 tools for this job, and parts cost about $180. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$180.00
Part Name Part Number Price Buy
Replacement 12-volt battery for 2002-2006 Acura RSX; verify group size, CCA, terminal layout, and VIN fitment — $180.00
Anti-corrosion terminal protectant or felt washers (optional) Optional — $8.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Verify battery fitment and charging symptoms

Group 51R, driver's-side engine bay — about 9-3/8 inches long, positive terminal right. Buy 51R (not plain 51), CCA at or above original. Save the radio code. Slow crank or clicking = battery; battery light running = alternator or belt.

🔧 Mechanic's note — Ray Delgado

I've seen plenty of RSXs show up with a plain Group 51 — the cables stretch and the terminals sit at a bad angle. The R in 51R is the whole job; double-check it on the label before you pay.

2

Make the vehicle safe and preserve settings when permitted

Park level, set the parking brake, ignition off, key removed. Memory saver optional only if the manual permits. Wear gloves and eye protection; keep tools off both posts. Bulging, cracked, or leaking battery: stop, let a shop swap it.

3

Disconnect the old battery

Remove the battery cover if equipped. Loosen the 10mm negative (-) clamp nut first, lift it off, tuck the cable aside, then the positive (+). Loosen the J-hook hold-down nuts, lift the bracket clear, and lift the battery out. Note cable routing.

🔧 Mechanic's note — Ray Delgado

In my experience, That negative clamp loves to corrode itself onto the post on these cars. Twist it side to side to break it free — never pry straight up with a screwdriver, you'll crack the battery post.

4

Compare and install the replacement

Compare old and new: same size, positive terminal right, CCA at or above original. Scrub the terminals clean. Refit the J-hook bracket, tighten evenly until it can't rock — snug, not gorilla-tight. Positive (+) first, then negative (-).

5

Reset and verify operation

No registration step. Start the engine: brisk crank, 13.5–14.5 volts across the posts running. Cycle each window down and up for auto. Battery light on, idle never settling, or hot battery with sulfur smell: switch off and test charging system.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Buying by appearance instead of group size, CCA, polarity, and hold-down fit
  • • Shorting the positive terminal to the body with a metal tool
  • • Lifting the battery by damaged terminals or leaving it unsecured
  • • Skipping battery registration, window/clock resets, or charging-system checks when required
  • • Assuming a new battery fixes a parasitic draw or charging fault