Quick answer: Wiper Blade Replacement on a 2004–2008 Acura TL is rated Easy and takes about 10–15 minutes. You'll need 1 tool for this job, and parts cost about $66. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| Driver wiper blade, 26" |
Bosch 26A |
$32.99 |
|
| Passenger wiper blade, 19" |
Bosch 19B |
$32.99 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm your TL’s blade sizes before buying
Every 2004–2014 TL takes a 26-inch driver blade and a 19-inch passenger blade. One older chart lists 24-inch for 2004–2011 drivers, so measure your old blade before buying — 26 inches is the consensus, but a tape measure settles it.
🔧 Mechanic's note — Ray Delgado
Don’t skip the tape-measure step on this one — I’ve seen parts stores hand out 24-inch blades for 2004–2011 TLs off an outdated chart. Thirty seconds with a tape measure beats a second trip to the store.
2
Park and lift the wiper arms
Park level, ignition off. The TL’s arms park on the cowl in the open — lift each arm until the spring holds it up. Lay a folded towel under each arm before removing a blade.
🔧 Mechanic's note — Ray Delgado
That big raked TL windshield gets hot enough to make fresh rubber drag and squeak on day one. I always do these in the shade — park under a tree or wait for evening and the first wipe will be silent.
3
Remove the 26-inch driver-side blade
Fold the driver’s arm up and rotate the blade perpendicular so the J-hook opening faces you. Press the release tab and slide the blade down off the end. If the old blade measures 24 inches, buy 24-inch replacements.
4
Install the new 26-inch driver-side blade
Slide the new 26-inch blade’s connector up onto the J-hook until it clicks over the locking tab. Pull firmly to confirm it is locked — a half-seated blade can walk off the hook. Lower the arm gently by hand.
5
Replace the 19-inch passenger-side blade
Repeat the tab-and-slide procedure on the passenger side with the 19-inch blade. The passenger blade is 7 inches shorter — check the box label; the two are easy to confuse once unwrapped. The long blade belongs on the driver side.
6
Clean the glass and check the washer system
Clean the windshield with glass cleaner or isopropyl alcohol — new blades chatter on dirty glass. With rain-sensing wipers, clean the sensor patch behind the rearview mirror carefully. Clear clogged washer jets and top off the washer reservoir while you are there.
7
Test the wipers on every speed
Switch the ignition on and test the washers, then run the wipers through intermittent, low, and high, watching for streaks, skipping, or clashing. Test the rain-sensing mode if equipped. Replace the blades yearly — the long driver blade’s outer tip wears first.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Blindly buying a 26-inch driver blade for a 2004–2008 TL — one older chart lists 24 inches, so measure the old blade and match it.
- • Buying blades without J-hook compatibility — the TL’s arms are plain small J-hook, and push-button-only blades will not mount.
- • Skipping the glass cleaning — the TL’s wide, raked windshield streaks badly with new blades if road film is left on it.