Quick answer: Front Lower Control Arm Bushing Replacement on a 2009–2016 Audi A4 is rated Advanced and takes about 2-3 hours. You'll need 8 tools for this job, and parts cost about $30. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| Front Lower Control Arm Bushing (confirm fitment for your 2009-2016 Audi A4's build date before ordering — M12 vs M14 ball joint) |
— |
$30.00 |
|
| Cotter pin (new) |
— |
— |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Safely raise and support the vehicle
Park on level ground, crack the lug nuts loose, then raise and support the vehicle on jack stands. Remove the wheel. Place a jack under the lower control arm or knuckle to support spring load before unbolting ball joints or bushings.
2
Mark alignment references and free the ball joint
Mark cam bolts or eccentric washers before removal so alignment can be approximated on reassembly. Remove the cotter pin and nut, then separate the ball joint from the knuckle with a pickle fork or separator — protect the boot on parts you're reusing.
🔧 Mechanic's note — Ray Delgado
I've learned: those eccentric washer positions are your only map back to the old alignment. A paint-pen mark takes five seconds and saves you from a car that pulls hard on the test drive.
3
Unbolt bushings and remove the control arm
Remove the inner control-arm bushing bolts/nuts at the subframe. Lower the arm carefully out of the vehicle. Note bolt orientation and any washers or flags that must go back the same way.
4
Compare the new control arm
Compare ball-joint taper, bushing style, and mounting holes to the old arm. Transfer any reusable sensors, brackets, or sway-bar end-link hardware only if the new arm is not fully loaded. Inspect the ball-joint boot for damage before install.
5
Install the new arm and torque fasteners
Position the new arm, start all bolts by hand, reconnect the ball joint, and torque to spec. Where bushings must be torqued at ride height, lower the vehicle onto supports or a jack under the arm before final torque so the bushings aren't preloaded wrong. Fit the cotter pin.
🔧 Mechanic's note — Ray Delgado
I've found that torquing control-arm bushings with the suspension hanging is the classic comeback — the bushing twists the moment the car sits down and tears itself apart. Always load the suspension to ride height before the final torque.
6
Reinstall the wheel and get an alignment
Reinstall the wheel, torque lug nuts in a star pattern, and lower the vehicle. Check for clunks on a short drive, then have a professional four-wheel alignment performed — control-arm work changes camber/caster.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Not properly securing the vehicle before starting the repair
- • Failing to clean and lubricate the new bushings during installation
- • Over-tightening bolts, which can damage components