← Back to Audi Q5 Guides

2018–2024 Audi Q5

2018-2024 Audi Q5 — Replace Air Filter

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 7, 2026

🔧 Easy 30 minutes $25 DIY 2 views

Save $125 by doing it yourself! Shop cost: $150

Quick answer: Replace Air Filter on a 2018–2024 Audi Q5 is rated Easy and takes about 30 minutes. You'll need 6 tools for this job, and parts cost about $25. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$25.00
Part Name Part Number Price Buy
Engine Air Filter C 17 013 $25.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Locate the Air Filter Box (T30 required!)

The 2018–2024 Q5 45 TFSI's (2.0L turbo) airbox is in the engine bay. Critical: the lid is secured by SIX T30 Torx screws — not hand clips — so a T30 driver is mandatory. Don't pry the lid or you'll break it.

2

Detach intake tube, remove six T30 screws

Detach the intake tube from the airbox lid first — one T30 screw is HIDDEN underneath it. Remove all six T30 screws and set them aside. Then lift the lid off.

🔧 Mechanic's note — Tom Becker

That hidden screw under the intake tube is the whole job's trap. I count screws into a tray — six out, six back — because one forgotten screw means a cracked lid or a whistling intake.

3

Remove the Old Filter

Lift the old panel filter out and note the orientation. If it's dirty, the 2.0T is restricted — the turbo needs clean air for full boost. Check for debris in the airbox.

4

Clean the Housing

Wipe the airbox clean and remove all dust and debris. Check the seal — the 2.0T's turbo needs a perfect intake seal — and make sure the sealing surfaces are clean. Don't touch the MAF sensor.

5

Install the New Filter

Install the new panel filter, matching the orientation. Make sure it seats flat with no gaps — a misaligned filter causes unmetered air, and the 45 TFSI's engine management is sensitive to it.

6

Close and Secure (all six screws!)

Replace the airbox lid and reinstall all SIX T30 screws — don't forget the hidden one under the intake tube (reattach the tube after). Tighten evenly without over-torquing the plastic. Close the hood and start the engine — the 2.0T should idle smoothly.

🔧 Mechanic's note — Ray Delgado

I snug those T30s by feel, not by force. The airbox is plastic, and a stripped screw boss means the lid never seals right again.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Forgetting to disconnect the battery before starting the repair
  • • Using incorrect tools, leading to damaged components
  • • Not properly securing the new air filter, causing air leaks
  • • Over-tightening screws, which can strip threads or crack plastic parts
  • • Failing to check for debris in the air filter housing before installing the new filter