← Back to BMW X3 Guides

2011–2017 BMW X3

2011-2017 BMW X3 — Replace Parking Light Bulb

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Nov 7, 2026

🔧🔧 Moderate 30 minutes $10 DIY 2 views

Save $125 by doing it yourself! Shop cost: $135

Quick answer: Replace Parking Light Bulb on a 2011–2017 BMW X3 is rated Moderate and takes about 30 minutes. You'll need 4 tools for this job, and parts cost about $10. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$9.96
Part Name Part Number Price Buy
Parking Light Bulb 63217160780 $9.96
LED Parking Light Bulb Optional W5W-LED $15.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Verify which lamp failed

On the 2011-2017 BMW X3 xDrive28i: turn on the tail lights and have a helper press the brake and operate the turn signal. Check the fuse if multiple rear lamps are dark.

2

Access the tail lamp housing

On the 2011-2017 BMW X3 xDrive28i: open the trunk/hatch. Remove the access cover, carpet flap, or exterior housing fasteners for the affected side. Support the lamp if you unbolt the whole assembly so wiring is not strained.

🔧 Mechanic's note — Ray Delgado

I support the lamp assembly so the wiring isn't strained — I've let one hang by its wires before, and the connector pulled halfway out.

3

Remove the old bulb or LED board

On the 2011-2017 BMW X3 xDrive28i: twist the bulb socket counterclockwise and pull it out, or unbolt/unclip the LED module if equipped. Pull a wedge bulb straight out of the socket. Note bulb number and orientation.

4

Install the correct replacement

On the 2011-2017 BMW X3 xDrive28i: match the bulb number (e.g., 3157, 7443, 1157) or OEM LED module. Seat the new bulb fully without touching halogen glass with bare fingers. Align LED boards and connectors exactly as removed.

🔧 Mechanic's note — Tom Becker

I match the bulb number and never touch halogen glass — I've killed a new bulb with fingerprints before, and it died within weeks.

5

Reassemble and test

On the 2011-2017 BMW X3 xDrive28i: refit the socket/module until locked, restore covers and fasteners, then test tail, brake, and turn functions. Confirm the housing seal is seated so water cannot enter the trunk or lamp.

🔧 Mechanic's note — Ray Delgado

I confirm the housing seal is seated before closing up — I've seen water in a lamp from a pinched seal, and the corrosion that follows is miserable.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Touching the new bulb with bare hands, which can shorten its lifespan due to oil residue.
  • • Failing to ensure the vehicle is turned off and the keys are removed before starting the repair.
  • • Forcing the bulb into the socket, which can damage the bulb or socket.