Quick answer: Engine Oil & Filter Change on a 2008–2019 BMW X6 is rated Moderate and takes about 30-60 minutes. You'll need 2 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.
Oil spec
3.0L turbo I6
Capacity 6.9 qt with filter Viscosity 5W-30 (alt: 0W-30) Spec BMW Longlife-01
| Part Name |
Part Number |
Price |
Buy |
| Engine Oil (5W-30) |
— |
$45.00 |
|
| Correct engine oil filter and drain-plug washer for 2008-2019 BMW X6 |
— |
$12.00 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm oil specification and make the vehicle safe
N55 3.0L turbo inline-six (xDrive35i): 6.5–7.0 US quarts of full-synthetic 5W-30 or 0W-30 meeting BMW Longlife-01 or Longlife-04. xDrive50i V8 or diesel owners: STOP — capacities and specs differ. Buy an N55 cartridge-element kit (element plus housing O-ring) and a new drain-plug crush washer.
2
Warm briefly and protect the work area
Idle 2–3 minutes, then shut off. Pop the hood and find the cartridge filter housing — a black plastic cap at the front-right of the engine bay. Remove the undertray panels blocking the drain plug (keep fasteners together) and loosen the filler cap to vent.
3
Drain the used oil and replace the filter
Remove the drain plug and let the oil drain until it slows to an occasional drip. Reinstall the plug with a NEW crush washer and tighten it to 25 Nm - BMW's spec, so use a torque wrench rather than guessing. From above, unscrew the black filter-housing cap with the housing wrench. Lift out the old cartridge element, note its orientation, and wipe the housing clean. Seat the new element exactly as the old one sat and install the NEW O-ring, coating it lightly with fresh oil so it seals without rolling.
🔧 Mechanic's note — Tom Becker
Twenty-five newton-meters is not a suggestion on this plug — I've seen X6 aluminum pans strip with one careless pull. If I didn't own a torque wrench, this job is where I'd buy one.
4
Install the correct oil quantity
Pour in 6 quarts, wait a full minute, then add the final half to full quart to land at 6.5–7.0 quarts. With no dipstick, staged filling is your only protection against overfilling. Reinstall the filler cap, refit all undertray panels, and lower the car.
5
Check level, leaks, and service reminder
Idle 1–2 minutes, watching the oil-pressure warning go out. Check via iDrive (Vehicle Info → Engine Oil Level), engine running on level ground: at or near maximum, never over.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Using the wrong viscosity, capacity, or filter
- • Working under a vehicle supported only by a jack
- • Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
- • Over-tightening the filter or drain plug
- • Starting the engine without first verifying oil was added