← Back to Cadillac SRX Guides

2010–2016 Cadillac SRX

2010-2016 Cadillac SRX — Brake Pad Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 14, 2026

🔧🔧🔧 Advanced 1-3 hours $205 DIY

Save $245 by doing it yourself! Shop cost: $450

Quick answer: Brake Pad Replacement on a 2010–2016 Cadillac SRX is rated Advanced and takes about 1-3 hours. You'll need 7 tools for this job, and parts cost about $205. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$205.00
Part Name Part Number Price Buy
Front or rear brake pad set for 2010-2016 Cadillac SRX; verify axle, brake package, and VIN fitment — $180.00
Replacement pad hardware or wear sensor only if the kit requires it — $25.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm axle, parts, and brake condition

SRX: dual-piston floating calipers (~48mm phenolic pistons). Match pads to SRX fitment; quality sets have wear-sensor tab, fiber shims. Micrometer-check rotors vs. minimum on hat. Tools: 13mm/18mm sockets, T30 bit, dual-piston compressor. Get caliper/bracket torque values from GM service info.

2

Lift and secure the vehicle

Level ground, Park, brake set. Crack lug nuts grounded; frame-stand one corner — never a jack alone. Chock rears; pull wheel, steer to working side. 18mm bracket bolts: very tight, breaker bar ready. Spot T30 rotor screw on rotor face.

3

Remove the caliper and old pads

Unbolt caliper (two 13mm); slide off. Wire-hook caliper to strut — never by hose. Pull pads, noting wear-tab position. Pull slide pins; degrease; inspect boots, hose. Rotors too? Remove 18mm bracket bolts, T30 screw; tap hat to break rust free.

4

Install pads and hardware

Wire-brush bracket lands; fit stainless clips. Pads in — wear tab as before, shims placed. Compress phenolic pistons (dual-piston spreader) — crack if cocked, so keep square, go slow; watch reservoir. Grease pins (silicone brake grease); seat boots; refit caliper.

🔧 Mechanic's note — Tom Becker

Phenolic pistons are brittle — I spread the pressure evenly with a dual-piston spreader and go slow. One cocked piston and you're buying a caliper.

5

Torque, pump, and bed in

Torque caliper/bracket hardware to GM service-info values; refit wheel; torque lug nuts star-pattern. Remove fluid above MAX line. Pump pedal until firm before driving. Bed pads: moderate stops from ~40 mph with cooling between; recheck lug nuts after ~50 miles.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Changing only one pad or mixing pad sets on an axle
  • • Working under a vehicle supported only by a jack
  • • Letting the caliper hang from the brake hose
  • • Forcing a seized piston or ignoring a leaking caliper
  • • Skipping final lug and caliper torque or the bedding procedure