← Back to Cadillac XT5 Guides

2017–2024 Cadillac XT5

2017-2024 Cadillac XT5 — Engine Oil & Filter Change

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧 Moderate 30-60 minutes $57 DIY

Save $63 by doing it yourself! Shop cost: $120

Quick answer: Engine Oil & Filter Change on a 2017–2024 Cadillac XT5 is rated Moderate and takes about 30-60 minutes. You'll need 2 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$57.00
Oil spec 3.6L V6 (LGX)
Capacity 6.0 qt with filter Viscosity 5W-30 (alt: 0W-30) Spec dexos1
Part Name Part Number Price Buy
Engine Oil (5W-30) — $45.00
Correct engine oil filter and drain-plug washer for 2017-2024 Cadillac XT5 Luxury AWD — $12.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm oil specification and make the vehicle safe

Verify the exact engine, oil viscosity, capacity, filter, and drain-plug seal for your 2017-2024 Cadillac XT5. Park on level ground, set the brake, chock the wheels, and raise the front on ramps or rated stands.

2

Warm briefly

Run the engine only long enough for the oil to flow, then shut it off. If you have the 2.0T (2020+), the fill is 5.0L of 0W-20 and the filter sits elsewhere -- confirm your engine on the underhood label before buying parts.

🔧 Mechanic's note — Tom Becker

GM's new-seal-every-time rule is not upselling -- I have seen reused crush seals weep for weeks. Toss a fresh seal in the parts bag before you crawl under; it is a two-dollar part.

3

Drain the oil and remove the old filter

Remove the drain plug and drain fully. Reinstall with a NEW seal and torque to 18 ft-lbs -- do not overtighten. Spin off the old canister filter, wipe the mounting surface, and confirm the old gasket came off with it. Spin on the new filter.

4

Install the correct oil quantity

Add the specified 5W-30 through a funnel — 6 quarts with a filter change on the 3.6L V6 — stopping short of the full mark, then verify with the dipstick and top up to the top line. If your XT5 has the 2.0L turbo instead (2020+), it takes 5.0L of 0W-20, not 6 quarts — check your engine before pouring. Keep the fill cap and dipstick clean.

5

Check level, leaks, and service reminder

Start the engine briefly, switch off, wait a few minutes, and recheck the level on level ground. Inspect the drain plug and filter for leaks. Reset the oil life system through the driver-information-center oil-life menu, and record the mileage, oil grade, and date.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Using the wrong viscosity, capacity, or filter
  • • Working under a vehicle supported only by a jack
  • • Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
  • • Over-tightening the filter or drain plug
  • • Starting the engine before checking the oil level and leaks