← Back to Chevrolet Impala Guides

2014–2020 Chevrolet Impala

2014-2020 Chevrolet Impala — Check Engine Light / OBD2 Diagnosis

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 14, 2026

🔧 Easy 15-30 minutes $25 DIY

Save $95 by doing it yourself! Shop cost: $120

Quick answer: Check Engine Light / OBD2 Diagnosis on a 2014–2020 Chevrolet Impala is rated Easy and takes about 15-30 minutes. You'll need 2 tools for this job, and parts cost about $25. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$25.00
Part Name Part Number Price Buy
OBD2 scanner — $25.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm warning severity

Steady with normal driving is a non-urgent emissions fault — book diagnosis soon. Flashing signals a severe misfire feeding raw fuel to the exhaust, which can overheat and destroy the converter: reduce speed, pull over safely, and tow it instead of driving on.

2

Connect the OBD-II scanner

Park, switch off, and find the 16-pin port under the driver's dash near the column — trapezoidal, any standard OBD-II scanner mates without force. Key or push-button to ON (engine off).

3

Read and record codes

Save every confirmed, pending, and permanent code with its freeze-frame snapshot before clearing anything. Also common are P0442/P0455 EVAP leak codes from the fuel cap, hoses, or canister, plus the occasional misfire or thermostat code.

🔧 Mechanic's note — Tom Becker

That hard-start-after-fill-up symptom is the giveaway I teach every apprentice: customer says 'it only cranks forever right after I get gas' — I don't even need the code, I check the purge valve first.

4

Check the likely cause

For P0496, check the canister purge solenoid on the engine: at idle there should be no vacuum on the canister side — steady suction means it's stuck open and needs replacement. Codes identify the system, not the part — test the valve before buying.

5

Repair, clear, and verify

Pay attention on your next fill-up: if the hard-start-after-refueling symptom is gone and the code stays cleared, the fix held. A returning P0496 means the purge valve or another EVAP component is still at fault.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Replacing parts based on a code without checking wiring, connectors, or vacuum leaks
  • • Clearing codes before recording confirmed, pending, and permanent codes
  • • Using a scanner that cannot communicate with the vehicle protocol
  • • Treating a stored code as proof that the named sensor itself failed