← Back to Chevrolet Suburban Guides

2015–2020 Chevrolet Suburban

2015-2020 Chevrolet Suburban — Cabin Air Filter Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 15–25 minutes $28 DIY

Save $72 by doing it yourself! Shop cost: $100

Quick answer: Cabin Air Filter Replacement on a 2015–2020 Chevrolet Suburban is rated Easy and takes about 15–25 minutes. You'll need 1 tool for this job, and parts cost about $28. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$28.00
Part Name Part Number Price Buy
Cabin air filter for 2015-2020 Chevrolet Suburban; verify arrows, size, and VIN/trim fitment — $28.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm fitment and find the filter

K2XX Suburban (2015–2020, LS/LT/LTZ/Premier): cabin filter sits behind the glove box, same as Tahoe and Silverado siblings. Check behind your glove box before forcing anything.

🔧 Mechanic's note — Ray Delgado

I don't assume my trim matches the video I watched — the side-trim-panel trucks surprise people, so I peek behind my glove box first, as the step says.

2

Prep the car and clear the glove box

Ignition off, key or fob with you so the blower stays silent. Empty the glove box completely — it'll be lowered or removed. If your trim has the side trim panel, have a Phillips or small socket ready for its fasteners, plus a flashlight.

3

Lower the glove box (or remove the trim panel)

Unhook the damper arm from the glove box's right side. Squeeze both side walls inward past the stops; let it rotate down on its hinges. If a side trim panel blocks access, pop it off first, then remove the insulator panel fasteners and panel.

4

Release the cover and remove the old filter

Release the rectangular cover's clips or tabs behind the glove box and pull it off. Slide the old filter straight out. Study the printed airflow arrow before discarding — the replacement must point the same way. Expect a gray, packed filter; Suburbans collect road dust.

5

Clean the housing and prep the new filter

Vacuum or wipe the housing and cover; keep debris out of the open slot — it leads straight to the blower. Hold the new filter against the old to confirm arrow direction; check the new frame is straight so it seals evenly.

6

Install the filter and reassemble

Slide the new filter in flat so edges seal; press the cover until clips catch. Reinstall insulator panel and fasteners, then snap the trim cover on. Swing the glove box up past the stops, rehook the damper arm, and confirm smooth open and close.

7

Test the HVAC and set a replacement habit

Run the fan low to high on fresh air: strong steady airflow at the passenger vents, no whistles or rattles (unseated cover or trim). Stale smell should clear immediately. Most replace yearly, sooner after dusty summers.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Forcing the glove box down on trims where the side trim panel must come off first, cracking the trim
  • • Reinstalling the filter cover without fully engaging its clips so air bypasses the filter
  • • Installing the new filter with the airflow arrow reversed
  • • Losing the small insulator-panel fasteners in the footwell during reassembly