← Back to Chevrolet Traverse Guides

2009–2017 Chevrolet Traverse

2009-2017 Chevrolet Traverse — Engine Air Filter Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 20-45 minutes $35 DIY

Save $75 by doing it yourself! Shop cost: $110

Quick answer: Engine Air Filter Replacement on a 2009–2017 Chevrolet Traverse is rated Easy and takes about 20-45 minutes. You'll need 1 tool for this job, and parts cost about $35. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$35.00
Part Name Part Number Price Buy
Engine air filter for 2009-2017 Chevrolet Traverse; verify engine, housing shape, and VIN fitment — $35.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Prep and locate the air box

Park the 2009-2017 Chevrolet Traverse on level ground, set the parking brake, and shut the engine off. Open the hood and locate the engine air filter housing: Black plastic air filter box near the front of the engine bay, connected to the ribbed intake duct (Lambda platform, shared with Enclave/Acadia/Outlook). The Traverse's Lambda platform is the surprise here — unlike most GM trucks that use clips, the Traverse's airbox lid is screwed down. Don't try to pry the clips; look for the screws around the perimeter.

2

Open the air filter housing

On the 2009-2017 Chevrolet Traverse, SCREWS — GM air box retainer screws hold the lid down (not tool-free clips; you'll need a screwdriver to remove them). Note the lid orientation for reinstall.

3

Remove the old filter and clean

Lift the old engine air filter out of the housing. The correct filter is: GM 15278634; FRAM CA10110; ACDelco equivalent. Inspect the old element — hold it up to light; if you can't see light through the pleats, it was overdue. Wipe the inside of the airbox with a clean microfiber cloth, keeping debris away from the intake tube opening. The screws thread into plastic — don't overtighten on reinstall or you'll strip them. Snug is enough.

🔧 Mechanic's note — Ray Delgado

I know this is the part people get wrong: The screws thread into plastic — don't overtighten on reinstall or you'll strip them.

4

Install the new filter

Seat the new filter (GM 15278634; FRAM CA10110; ACDelco equivalent) in the Chevrolet Traverse housing with the rubber seal fully seated in the groove. An unseated filter lets dirt directly into the 3.6L V6, causing premature engine wear.

5

Reseal and verify

Close the air-box lid evenly — press down uniformly so the seal compresses equally. Refasten every clip or screw. Double-check the intake tube clamps are snug. Take a short test drive. Interval: Every 15,000-30,000 miles or once a year.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Confusing the engine filter with the cabin filter
  • • Installing the filter upside down or leaving a corner unseated
  • • Dropping clips, dirt, or shop towels into the intake tract
  • • Over-tightening plastic air-box fasteners
  • • Failing to double-check the intake tube clamps are snug.