← Back to Chevrolet Traverse Guides

2018–2023 Chevrolet Traverse

2018-2023 Chevrolet Traverse — Check Engine Light / OBD2 Diagnosis

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 14, 2026

🔧 Easy 15-30 minutes $25 DIY

Save $95 by doing it yourself! Shop cost: $120

Quick answer: Check Engine Light / OBD2 Diagnosis on a 2018–2023 Chevrolet Traverse is rated Easy and takes about 15-30 minutes. You'll need 2 tools for this job, and parts cost about $25. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$25.00
Part Name Part Number Price Buy
OBD2 scanner — $25.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm warning severity

A steady light with the 3.6-liter V6 running normally is a fault to diagnose soon. A flashing light signals a severe misfire that can overheat the catalytic converters — back off the throttle and arrange diagnosis promptly instead of driving hard.

2

Connect the OBD-II scanner

Switch the ignition ON and connect. A scanner showing live data is important for this V6: camshaft/crankshaft correlation PIDs, desired versus actual cam angles, fuel trims, and misfire counters are the values that matter.

3

Read and record codes

Write down every confirmed, pending, and permanent code plus freeze-frame data before clearing anything. The 3.6L V6 family is documented for timing-correlation faults — P0008, P0016, P0017, P0018, P0019 — from stretched timing chains or worn guides, appearing with a brief rattle on cold startup.

4

Check the likely cause

For P0496, test the purge solenoid for vacuum at idle on the canister side; for EVAP leaks, reseat the cap and trace hoses. Never clear a timing code and assume it is fixed.

🔧 Mechanic's note — Tom Becker

I've trained my ears for this one: Never clear a timing code and call it fixed — that's the most expensive reset in this whole chunk. A jumped chain can lunch the engine, and the rattle on cold starts is your last warning.

5

Repair and verify

Rescan afterward — a returning P0008/P0017 means the timing fault is real and needs professional repair promptly, since a jumped chain can cause severe engine damage. A purge-valve fix is confirmed by clean starts after your next fill-up.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Replacing parts based on a code without checking wiring, connectors, or vacuum leaks
  • • Clearing codes before recording confirmed, pending, and permanent codes
  • • Using a scanner that cannot communicate with the vehicle protocol
  • • Treating a stored code as proof that the named sensor itself failed