← Back to Acura TSX Guides

2009–2014 Acura TSX

2009-2014 Acura TSX — Engine Oil & Filter Change

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧 Moderate 30-60 minutes $57 DIY

Save $63 by doing it yourself! Shop cost: $120

Quick answer: Engine Oil & Filter Change on a 2009–2014 Acura TSX is rated Moderate and takes about 30-60 minutes. You'll need 2 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$57.00
Oil spec 2.4L I4 (K24Z3)
Capacity 4.2 qt with filter Viscosity 0W-20 (alt: 5W-20) Spec API SN, ILSAC GF-5
Part Name Part Number Price Buy
Engine Oil (0W-20) — $45.00
Correct engine oil filter and drain-plug washer for 2009-2014 Acura TSX — $12.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm oil specification and make the vehicle safe

The 2.4L K24Z3 takes 4.2 quarts of 0W-20 with a new filter (Acura back-spec'd this engine to 0W-20; the manual also allows 5W-20). Buy a fresh aluminum drain washer. Park level, raise the front on ramps or stands.

🔧 Mechanic's note — Tom Becker

Honda's aluminum crush washer seals by deforming — I never reuse the old one, because it will weep within days of the change.

2

Warm briefly and protect the work area

Stage the filter, wrench, drain pan, and washer. Idle two to three minutes to warm the oil, shut off, wait briefly. Remove the fill cap to vent and position the pan under the drain plug.

3

Drain the used oil and replace the filter

Remove the drain plug, drain fully, refit with a fresh washer torqued to 30 ft-lb — K-series pan threads strip easily. Spin off the filter above the axle; confirm the old gasket came off, oil the new gasket, install hand-tight plus a quarter turn.

🔧 Mechanic's note — Tom Becker

Loosened oil drips right onto the driveshaft on this engine — I wipe the shaft clean afterward or the car smells like burning oil for a week.

4

Install the correct oil quantity

Pour 3.7 of the 4.2 quarts of 0W-20 through a funnel and hold back the last half quart. Wait a few minutes, then check the dipstick.

5

Check level, leaks, and service reminder

Start briefly, switch off, wait two minutes, recheck on level ground and top to the full mark. Inspect the plug and filter base for leaks; reset the maintenance minder through the steering-wheel controls. Log the date, mileage, and oil used.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Using the wrong viscosity, capacity, or filter
  • • Working under a vehicle supported only by a jack
  • • Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
  • • Over-tightening the filter or drain plug
  • • Starting the engine before checking the oil level and leaks