2010–2017 Chevrolet Equinox
By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026
Save $490 by doing it yourself! Shop cost: $575
Quick answer: Heater Blower Motor on a 2010–2017 Chevrolet Equinox is rated Moderate and takes about 45 minutes. You'll need 5 tools for this job, and parts cost about $85. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name | Part Number | Price | Buy |
|---|---|---|---|
| Blower Motor | TRQ HMA84805 | $84.95 |
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Follow these steps carefully
Disconnect the negative battery cable. Wear gloves; sharp sheet-metal edges are common.
I pull the Equinox negative cable and tuck it behind the fuse box. The blower motor is right under the dash and I will be upside down in the footwell — I cannot see the battery from there, so the cable gets tied off.
Unplug the blower motor connector. If a blower resistor or control module is attached inline, note its orientation and whether it shares screws with the motor cover. Inspect for heat damage or water intrusion.
On the 2010-2017 Chevrolet Equinox 2.4L: remove the retaining screws and lower the blower motor out of the housing. Catch any debris or leaves that fall from the scroll. Do not bend the fan cage.
Match connector style, cage diameter, and mounting flange to the old motor. Vacuum leaves and dust from the HVAC housing opening so the new cage does not hit debris. Transfer any foam seals if not included on the new unit.
I compare connector style, cage diameter, and the mounting flange on the new Equinox blower motor before installing it. The wrong cage size will rub the housing and sing at every fan speed.
Seat the new blower so the cage clears the housing, install screws evenly, and reconnect the electrical connector. Reinstall trim panels. Reconnect the battery negative cable.
I install the new Equinox blower and reconnect it — I listen for the click, then I give it a firm tug. I have seen a blower quit on a hot day from a connector that backed out, and the customer was not happy.
Key-on and run the Chevrolet Equinox blower through all speeds in vent mode. Confirm strong airflow with no scraping, squeal, or intermittent cut-out. Recheck dash panels for rattles after a short drive.
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
2010–2017
2010–2017
2010–2017
2010–2017
2018–2024
2018–2024
