← Back to Volvo S90 Guides

2017–2024 Volvo S90

2017-2024 Volvo S90 — Replace Starter Motor

🔧🔧🔧 Advanced 2-3 hours $530 DIY 2 views

Save $670 by doing it yourself! Shop cost: $1,200

Quick Video Tutorial

Parts You Need

Click links to purchase (we earn from qualifying purchases)

Total Cost
$530.00
Part Name Part Number Price Buy
Starter Motor 314-1001 $500.00
Starter Motor Gasket 314-1002 $20.00
Battery Terminal Cleaner 314-1003 $10.00

About prices: shown prices are estimates from typical Amazon listings and change frequently, and cheaper alternatives may be available. Confirm the current price on Amazon before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Disconnect the battery and raise the vehicle if needed

Always disconnect the negative battery cable first. On the Volvo S90, the starter is typically on the bellhousing — access may be from above or below. If you must raise the vehicle, use a floor jack on a solid lift point and support with jack stands on level ground. Wear eye protection.

2

Locate the starter and disconnect wiring

Identify the B+ battery cable and the solenoid trigger wire/connector on the starter. Remove the nut and cable, then unplug the trigger connector. Cap or tape the battery cable end so it cannot short to ground.

3

Support the starter and remove mounting bolts

Support the starter body, then remove the mounting bolts (often 13–15 mm). Lower or lift the starter out clear of the bellhousing. Note any heat shield, bracket, or alignment dowel that must transfer to the new unit.

4

Compare the new starter

Compare nose length, clocking of the solenoid, mounting ears, and pinion gear to the old starter. Transfer any brackets or heat shields. Confirm the drive gear turns freely by hand.

5

Install the new starter and reconnect cables

Maneuver the new starter into place, start the mounting bolts by hand, then tighten evenly to spec. Reconnect the solenoid trigger connector and the B+ cable; tighten the cable nut firmly without stretching the terminal.

6

Reconnect the battery and test cranking

Reconnect the negative battery cable. Verify the Volvo S90 cranks strongly without grinding or slow-spin symptoms. Confirm no chafed wiring and that any underbody shields are reinstalled before a final road check.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Not disconnecting the battery before starting the repair
  • • Forgetting to torque bolts to manufacturer specifications
  • • Overlooking the need to replace the starter motor gasket