Quick answer: Wiper Blade Replacement on a 2006–2013 Chevrolet Impala is rated Easy and takes about 10–15 minutes. You'll need 1 tool for this job, and parts cost about $66. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| Driver wiper blade, 22" |
Bosch 22A |
$32.99 |
|
| Passenger wiper blade, 22" |
Bosch 22B |
$32.99 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm the Impala’s sizes for 2006–2013
Every 2006–2013 Impala takes a 22-inch blade on each side — equal lengths, so label the boxes. Fronts fit 9×3 J-hook arms. One retailer lists a 21-inch for the 2013 passenger side — measure the old blade before buying.
🔧 Mechanic's note — Ray Delgado
The 2013 21-inch passenger rumor is real at one retailer — I've seen it in their catalog too. Thirty seconds with a tape measure before you buy saves a return trip.
2
Park and lift the wiper arms
Park level, shift into Park, ignition off. The wipers park on the open cowl — no service position — so lift each arm. Both blades are 22 inches, so mark driver vs. passenger. Lay a folded towel under each arm.
3
Remove the driver-side 22-inch blade
Fold the driver's arm up and rotate the blade perpendicular so the J-hook faces you. Press the release tab and slide the blade off the hook. Rest the bare arm on the towel; never let it snap onto bare glass.
4
Install the new driver-side 22-inch blade
Slide the new blade's connector onto the J-hook until it clicks. Tug to confirm it's seated — a half-latched blade slides off the first time you use the washers. Rotate the blade, lower the arm, and check it lies flat.
5
Replace the passenger-side 22-inch blade
Repeat on the passenger side: arm up, blade perpendicular, press the tab, slide the old off, click the new on. Both blades are identical in length, so keep the boxes labeled. Check from outside that they park neatly without overlapping.
🔧 Mechanic's note — Ray Delgado
Both blades being identical is the trap on this car — I've watched people mount them without marking and then wonder which side is which when one streaks. Keep the boxes labeled.
6
Clean the glass and check the washer system
With both blades on, clean the windshield — new blades chatter on dirty glass. Check the washer jets and clear clogs with a pin. Pull leaves or needles out of the cowl grille; debris around the linkage slows the wipers.
7
Test the wipers on every speed
Switch the ignition on and test the washers, then run every wiper speed, watching for streaks, skipping, or blades hitting each other. If a blade streaks in one direction only, re-seat it — the connector probably missed the locking tab.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Assuming the 2013 passenger blade is 22 inches without checking — one fitment chart lists 21 inches for that year, so measure the old blade first.
- • Losing track of driver versus passenger — both blades are 22 inches, so label the boxes before opening them.
- • Skipping the cowl cleanout — leaves packed around the Impala’s wiper linkage cause slow, noisy wiping that new blades alone will not fix.