Quick answer: Wheel Bearing Replacement on a 2012–2018 Ford Focus is rated Advanced and takes about 2-3 hours. You'll need 9 tools for this job, and parts cost about $50. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| Front Wheel Bearing and Hub Assembly |
BHA33288 |
$49.95 |
|
| Rear Wheel Bearing and Hub Assembly Optional |
BHA54395 |
$82.95 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Loosen lugs and support the vehicle
On the 2012-2018 Ford Focus: on level ground, crack the lug nuts loose on the noisy corner. Chock the opposite wheels, jack at the approved lift point, and support with jack stands. Remove the wheel. Wear eye protection.
2
Remove brakes and free the hub area
On the 2012-2018 Ford Focus: remove the caliper and bracket, hang the caliper (do not stretch the hose), and remove the rotor. If the rotor is seized, use penetrating oil and careful taps.
🔧 Mechanic's note — Tom Becker
I hang the caliper and never let it stretch the hose — I've seen a stretched brake hose fail weeks later, and the cause was that one afternoon.
3
Disconnect knuckle attachments as needed
On the 2012-2018 Ford Focus: remove the axle nut (often a high-torque nut — use a breaker bar with the brakes held or an impact carefully). Free the tie rod or ball joint only if needed for hub clearance.
4
Remove the old hub bearing assembly
On the 2012-2018 Ford Focus: remove the hub-to-knuckle bolts from the back of the knuckle and press/tap the hub assembly out evenly.
5
Install the new bearing and hub
On the 2012-2018 Ford Focus: compare ABS ring and connector orientation on the new hub. Reinstall the axle through the hub and torque a new axle nut if required — never reuse a stretch nut unless the manual allows it.
🔧 Mechanic's note — Ray Delgado
I compare the ABS ring orientation on the new hub — I've installed one backwards before, and the ABS light came on before I left the driveway.
6
Reassemble and torque
On the 2012-2018 Ford Focus: reinstall the rotor and caliper, torque bracket and lug nuts to spec, reconnect ABS, and lower the vehicle. Pump the brake pedal before moving.
🔧 Mechanic's note — Tom Becker
I pump the brake pedal before the Focus moves — I've rolled with a soft pedal after a brake job once, and the scare cured me permanently.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Not properly securing the vehicle before starting the repair
- • Failing to torque bolts to manufacturer specifications
- • Using incorrect tools or parts not compatible with the vehicle model