EZCarFix DIY Auto Repair
← Back to Mercury Milan Guides

2006–2011 Mercury Milan

2006-2011 Mercury Milan — Front Brake Pad Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 24, 2026 · Updated Oct 14, 2026

🔧🔧 Moderate 60–90 minutes $80 DIY

Save $285 by doing it yourself! Shop cost: $365

Quick answer: Front Brake Pad Replacement on a 2006–2011 Mercury Milan is rated Moderate and takes about 60–90 minutes. You'll need 7 tools for this job, and parts cost about $80. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$80.00
Part Name Part Number Price Buy
Front ceramic brake pad set with hardware — $53.00
Brake cleaner spray — $10.00
Silicone brake grease — $17.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Raise the Milan and remove the wheel

Park on level pavement, loosen the front lug nuts, then raise the front on jack stands and remove the wheel. Turn the steering to full lock for the clearest caliper view. Inspect pads, rotor, caliper, and hose for obvious damage.

2

Unbolt the caliper and remove the pads

Remove the two guide bolts, lift the caliper off the rotor, and hang it from the strut with wire — never let it hang by the hose. Pull the worn pads from the bracket and note the wear-indicator positions.

3

Remove the rotor and clean the hub face

If replacing or resurfacing the rotor, unbolt the bracket and lift the rotor off. Wire-brush the hub's mating surface rust-free so the rotor sits flat — a rusty hub face is the main cause of post-job pedal pulsation.

🔧 Mechanic's note — Ray Delgado

I never skip the hub-face cleaning — it's exactly why the pedal pulses a week later, and I've learned five minutes with a wire brush is the cheapest insurance on this whole job.

4

Compress the caliper piston

Press the piston straight back with a compressor tool or C-clamp and an old pad. Open the reservoir cap first and watch the fluid level so it doesn't overflow. Retract the piston fully so the thicker new pads fit.

5

Install hardware, grease, and new pads

Install the new stainless hardware clips in the bracket and apply silicone brake grease sparingly to the pad ears and backs where they meet the caliper. Slide the pads in with the wear sensor correctly positioned. Everything should move freely.

6

Reassemble, torque, and bed the pads

Refit the rotor and bracket if removed, then the caliper; torque the guide bolts. Mount the wheel, lower the car, and torque the lugs in a star pattern. Pump the pedal until firm, then bed the pads with moderate stops.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Hanging the caliper by the brake hose instead of supporting it, which can damage the hose internally.
  • • Reusing swollen or torn guide-pin boots, letting water corrode the pins until the caliper seizes.
  • • Not pumping the brake pedal before driving, causing a terrifying no-brake moment on the first stop.