EZCarFix DIY Auto Repair
← Back to BMW X7 Guides

2019–2024 BMW X7

2019-2024 BMW X7 — Change Oil

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Nov 6, 2026

🔧🔧 Moderate 1 hour $65 DIY 3 views

Save $310 by doing it yourself! Shop cost: $375

Quick answer: Change Oil on a 2019–2024 BMW X7 is rated Moderate and takes about 1 hour. You'll need 6 tools for this job, and parts cost about $65. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$65.00
Part Name Part Number Price Buy
Engine Oil (SAE 0W-30) 83 21 2 365 950 $50.00
Oil filter cartridge element kit (with O-rings) 11427512227 $15.00
Drain plug copper crush washer — —

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Prepare the Vehicle

The 2019–2024 X7 M50i (N63 4.4L twin-turbo V8) takes SAE 0W-30 BMW Longlife-01 FE — do NOT use 0W-20. Capacity is 10.5 liters (~11.1 quarts), so buy three 5-qt jugs. You'll need: cartridge filter (topside), new copper crush washer (M18x1.5 plug, 40 Nm).

2

Lift and Secure the Vehicle

Raise the X7 and support it with high-capacity jack stands — it weighs 5,500+ lbs. Chock the wheels. Remove the extensive undertray to reach the drain plug. The filter is topside under the engine cover; you only go under for the drain plug.

3

Drain the Old Oil

Position a large drain pan (11+ quart capacity). Remove the drain plug (40 Nm on reinstall with a NEW copper crush washer — do not reuse). Let the 10.5L drain fully, about 15–20 minutes; N63 oil runs dark from twin-turbo heat.

4

Replace the Oil Filter (topside)

Open the hood, remove the engine cover, and take off the filter housing cap. Pull the old cartridge out, replace the O-ring (included with the new filter), and insert the new element. Cap procedure: 40 Nm, slacken 180°, then 40 Nm final.

🔧 Mechanic's note — Ray Delgado

I've learned: that 40 Nm, slacken 180°, then 40 Nm sequence isn't decoration — BMW designed it to seat the housing without crushing the O-ring. Skip the sequence and you'll be back under the hood chasing a filter-housing weep.

5

Reinstall the Drain Plug

Reinstall the drain plug (M18x1.5) with a new copper crush washer and torque to 40 Nm — do not reuse the washer. Wipe clean, reinstall the undertray and engine cover.

6

Add New Oil and Verify via iDrive

Lower to level ground and add 10.5L (~11.1 qt) of 0W-30 LL-01 FE. With the engine at operating temperature, check the level via iDrive (Vehicle Info > Oil Level) and top up if low. Check for leaks and reset the service indicator.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Not allowing the engine to cool before starting the oil change
  • • Failing to properly torque the drain plug and oil filter
  • • Overfilling or underfilling the engine with oil