EZCarFix DIY Auto Repair
← Back to Chevrolet Cruze Guides

2016–2019 Chevrolet Cruze

2016-2019 Chevrolet Cruze — Cabin Air Filter Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 15–20 minutes $28 DIY

Save $72 by doing it yourself! Shop cost: $100

Quick answer: Cabin Air Filter Replacement on a 2016–2019 Chevrolet Cruze is rated Easy and takes about 15–20 minutes. Parts cost about $28. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$28.00
Part Name Part Number Price Buy
Cabin air filter for 2016-2019 Chevrolet Cruze; verify arrows, size, and VIN/trim fitment — $28.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm you have the second-generation Cruze

For the redesigned second-gen Cruze, 2016–2019. One trap: 2016 also included the Cruze Limited, a carryover with a different glove box and filter. Check your badges and door jamb sticker — if it says Limited, find the older-car procedure.

2

Empty and lower the glove box

Empty the glove box. Find the descent damper and unhook it from its pin. Press the two stoppers on the box walls inward, following the molded arrows, and let the box tilt down until it hangs open.

🔧 Mechanic's note — Ray Delgado

In my experience, That descent damper unhooks from its pin with a gentle pull — don't yank it. The plastic bracket behind it cracks easily, and then your glove box flops open every time you brake.

3

Open the three-tab filter housing

Behind the lowered glove box, on the HVAC case, the filter housing door is held by three locking tabs. Release all three and swing the door down — it hinges at the bottom — to expose the filter slot.

4

Remove the old filter

Slide the old filter straight out. Note its airflow arrow direction and check the media — blackened pleats or a sour smell explain weak airflow or odors. Peek into the empty housing and pull out any leaves or debris.

5

Install the new filter

Confirm the new filter's size against the old one. Slide it in with the airflow arrow facing the same direction, pushing straight and fully — it should bottom out with no corner sticking up, so air can't leak around it.

6

Close up the housing and glove box

Swing the housing door up and press until all three tabs click — run a finger along the seam to confirm. Raise the glove box, pop the two stoppers back out, and reattach the descent damper to its pin.

7

Test the fan

Start the car and run the fan from low to high. Airflow should be strong and steady with no rattling behind the dash — a buzz usually means a housing tab isn't seated. Close the glove box and you're done.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Doing this job on a 2016 Cruze Limited — that badge means the older car, which has a different glove box and filter arrangement than the redesigned 2016–2019 Cruze this guide covers.
  • • Forcing the glove box down without first unhooking the descent damper, which can tear the damper mount off the box.
  • • Opening the housing by yanking one tab and twisting the door, which warps the door so it never seals again.
  • • Seating the new filter crooked so air bypasses it — slide it in straight until it bottoms out.