EZCarFix DIY Auto Repair
← Back to Chevrolet Cruze Guides

2011–2015 Chevrolet Cruze

2011-2015 Chevrolet Cruze - Battery Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 25–40 minutes $147 DIY

Save $133 by doing it yourself! Shop cost: $280

Quick answer: Battery Replacement on a 2011–2015 Chevrolet Cruze is rated Easy and takes about 25–40 minutes. You'll need 2 tools for this job, and parts cost about $147. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$147.00
Part Name Part Number Price Buy
Correct group-size battery — $140.00
Terminal cleaner Optional — $8.00
Terminal protectant — $7.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Find the battery under the trunk floor, not the hood

Park level, brake set, ignition off. Empty the trunk and lift out the carpet, floor cover, and any foam tray or inflator kit.

2

Remove the hold-down and note the vent hose

Unbolt the hold-down across the battery's top. Before loosening any cable, pull the small vent hose off the battery's side and note its routing — this trunk battery must vent outside the cabin, and the replacement needs the hose reconnected.

3

Disconnect the negative cable and inspect its clamp

Loosen the negative clamp with a 10mm wrench or socket, wiggle the cable off the post, and tuck it where it can't touch metal. Inspect the clamp: GM issued special coverage for 2011–2015 Cruzes for weak crimps causing intermittent failures.

🔧 Mechanic's note — Tom Becker

I know GM's special coverage on this weak negative-clamp crimp is real. If the clamp is loose or heat-discolored, get the cable replaced instead of reusing it — intermittent electrical gremlins on these Cruzes almost always trace back here.

4

Disconnect the positive cable and lift the battery out

Loosen the positive (red) terminal clamp the same way and slide the cable off the post, keeping it clear of the negative cable. With both cables free and the hold-down removed, grip the battery with both hands and lift it straight up out of the trunk recess — it is a long reach over the trunk lip, so keep your back straight and the battery level. Set it upright on the ground where it cannot tip over.

5

Clean the recess and verify the replacement

Wipe out the battery recess and check for moisture or debris trapped under the floor cover. Scrub the inside of both cable clamps with a wire brush until bright metal shows, and make sure the vent hose is not cracked or clogged.

6

Install the battery, vent hose, and cables

Refit the hold-down until the battery can't shift. Reconnect positive first, negative last; tug each clamp to confirm seating, then coat the terminals with dielectric grease or terminal spray.

7

Reassemble the trunk and relearn the windows

Start the engine and confirm strong cranking, working lights, and no new warning lights on the dash. Check your owner’s manual after any battery disconnect on this car: it notes that the front power windows’ express-up feature may need to be relearned.

🔧 Mechanic's note — Ray Delgado

In my experience, the express-up window relearn catches everyone off guard — you finish the battery swap, and suddenly the window won't auto-up. Don't panic and don't buy a regulator; just run the manual's procedure with the doors closed and the ignition in run.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Hunting for the battery under the hood and giving up — on the US-market 2011–2015 Cruze it is in the trunk, and the under-hood posts are jump terminals only.
  • • Forgetting to reconnect the vent hose — a trunk-mounted battery must vent outside the cabin.
  • • Reusing a damaged negative cable clamp — GM flagged a weak crimp on this exact clamp for 2011–2015 Cruzes, so inspect it instead of blindly reusing it.