Quick answer: Sliding Door Module Replacement on a 2017–2025 Chrysler Pacifica is rated Moderate and takes about 2-3 hours. You'll need 10 tools for this job, and parts cost about $274. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| Sliding Door Control Module |
68369596AA |
$129.99 |
|
| Sliding Door Wiring Harness |
68228638AE |
$43.97 |
|
| Sliding Door Actuator |
68225094AE |
$100.01 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm module fault vs. cable/track issue
On the 2017-2025 Chrysler Pacifica: scan for power sliding-door module codes and test switch/obstruction behavior. If the door moves but reports module faults, proceed with module replacement; if it binds mechanically, fix cables/tracks first.
🔧 Mechanic's note — Tom Becker
Scan it before you buy the module — I have seen just as many Pacifica doors fixed with a cable or track repair as with a module. A binding door will burn out a new module fast.
2
Disconnect the battery
On the 2017-2025 Chrysler Pacifica: disconnect the negative battery cable to prevent accidental door motion and airbag issues. Open the affected sliding door fully and support it so it cannot roll closed.
3
Access the sliding door control module
On the 2017-2025 Chrysler Pacifica: remove the door trim panel or rear quarter trim as specified to reach the sliding door control module. Photograph connector orientation.
4
Remove the old module
On the 2017-2025 Chrysler Pacifica: unplug electrical connectors and unbolt the module from its bracket. Avoid pulling on wiring harnesses.
5
Install the new module and reconnect
On the 2017-2025 Chrysler Pacifica: mount the new module, torque fasteners, and reconnect every connector until it clicks. Refit vapor barriers and trim panels correctly to keep water out.
6
Reconnect battery, code/initialize, and test
On the 2017-2025 Chrysler Pacifica: reconnect the battery. Clear codes and perform any door module initialization with a scan tool if required. Cycle the sliding door from outside/inside switches and the fob; confirm soft-close and obstruction reverse work.
🔧 Mechanic's note — Ray Delgado
I tell everyone in my shop to do the scan-tool initialization after the swap — without it the door may work, but the soft-close and obstruction reverse will not, and that is a safety feature, not a convenience.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Forgetting to disconnect the vehicle's battery before starting the repair
- • Not properly securing the door during removal, leading to potential injury or damage
- • Over-tightening screws or bolts, which can strip threads or damage components
