EZCarFix DIY Auto Repair
← Back to Fiat 500L Guides

2014–2020 Fiat 500L

2014-2020 Fiat 500L — Cabin Air Filter Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 24, 2026 · Updated Oct 14, 2026

🔧 Easy 20–30 minutes $20 DIY

Save $83 by doing it yourself! Shop cost: $103

Quick answer: Cabin Air Filter Replacement on a 2014–2020 Fiat 500L is rated Easy and takes about 20–30 minutes. You'll need 3 tools for this job, and parts cost about $20. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$20.00
Part Name Part Number Price Buy
Cabin / pollen air filter (correct application for 2014–2020 Fiat 500L) — $20.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Clear the glove box and passenger footwell

Empty the glove box and clear the passenger footwell so you have room to work, then open the glove box door. On the 500L the cabin filter lives behind the glove box in the HVAC housing.

2

Remove the glove box

Remove the Torx screws along the top edge and sides of the glove box frame. Pull the glove box straight out toward the rear and set it on the seat. Keep the screws in a cup so none roll away.

3

Locate the filter access cover

On the exposed HVAC housing, find the narrow rectangular cover held by clips or small screws. Release the clips or remove the screws and pull the cover off. The old pollen filter's edge is now visible.

4

Note the airflow arrow and remove the old filter

Note the arrow direction on the old filter before sliding it out. Pull it slowly; 500L filters often come out full of leaves and dust. Wipe the empty slot with a damp cloth so debris does not enter the blower.

5

Fit the new filter in the correct orientation

Slide the new pollen filter in with its airflow arrow matching the old one. It should glide in without force; if it binds, realign rather than crumple the pleats. Confirm it is fully seated edge to edge.

🔧 Mechanic's note — Tom Becker

If the new filter binds going in, I pull it back out and realign it instead of forcing it — I've crumpled pleats before, and unfiltered air slipped past the edges and made the whole job for nothing.

6

Reinstall the cover and glove box

Refit the access cover and its clips or screws. Slide the glove box back into the dash, engaging its alignment tabs, and reinstall all the Torx screws. Close the glove box and check that it opens and latches smoothly.

7

Run the HVAC to verify

Start the 500L and run the blower on high through the dash and windshield vents. Strong, even airflow with no rattling behind the dash confirms the job is done. The cabin should also smell noticeably fresher within a few minutes.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Installing the filter with the airflow arrow reversed, cutting filtration effectiveness.
  • • Losing the small Torx screws inside the dash during reassembly.
  • • Cracking the glove box frame by forcing it out before all screws are removed.
  • • Leaving the access cover off, which causes a loud air leak behind the dash.
  • • Using a filter for the regular Fiat 500 instead of the larger 500L filter.