EZCarFix DIY Auto Repair
← Back to Fiat 500L Guides

2014–2020 Fiat 500L

2014-2020 Fiat 500L — Engine Oil & Filter Change

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧 Moderate 30-60 minutes $57 DIY

Save $63 by doing it yourself! Shop cost: $120

Quick answer: Engine Oil & Filter Change on a 2014–2020 Fiat 500L is rated Moderate and takes about 30-60 minutes. You'll need 3 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$57.00
Oil spec 1.4L turbo I4
Capacity 4.0 qt with filter Viscosity 5W-40
Part Name Part Number Price Buy
Engine Oil (5W-40) — $45.00
Correct engine oil filter and drain-plug washer for 2014-2020 Fiat 500L — $12.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm oil specification and make the vehicle safe

Verify the exact engine, oil viscosity, capacity, filter element, and drain-plug washer for the 2014-2020 Fiat 500L. The 1.4L MultiAir Turbo takes 4 quarts of 5W-40 meeting Fiat spec 9.55535. Note the filter is a cartridge ELEMENT inside a housing that is part of an assembly with the oil cooler — on the front side of the engine block, toward the passenger side — not a spin-on canister. Park on level ground, set the parking brake, chock the wheels, and raise the front on ramps or rated jack stands.

2

Warm briefly and protect the work area

Warm the engine briefly, then shut off. Remove the fill cap and place a drain pan under the sump. Remove the under-engine splash shield to expose the housing and plug — a tight-space filter wrench and 27mm socket earn their keep here.

3

Drain the used oil and replace the filter

Open the cartridge housing FIRST with the 27mm socket, then remove the drain plug and drain fully. Reinstall the plug with a fresh washer without overtightening. Swap the paper element, fit the new O-ring lightly oiled, and refit the housing. Reinstall the splash shield.

🔧 Mechanic's note — Tom Becker

Filter housing first, drain plug second — that's the order that matters on the 500L. Open the plug first and you'll leave a housing full of dirty oil in the system. I see DIYers get this backwards all the time.

4

Install the correct oil quantity

Add 5W-40 — 4 quarts total — stopping short of the full mark, then top up to the top line. Pour slowly: the fill neck is narrow and the sump is small.

5

Check level, leaks, and service reminder

Start briefly, switch off, wait a few minutes, and recheck the level on level ground. Inspect the plug and filter/cooler housing for leaks. Turbos are hard on oil — stick to the 9.55535 spec and don't stretch the interval.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Using the wrong viscosity, capacity, or filter
  • • Working under a vehicle supported only by a jack
  • • Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
  • • Over-tightening the filter or drain plug
  • • Starting the engine before checking the oil level and leaks