EZCarFix DIY Auto Repair
← Back to Lincoln Continental Guides

2017–2020 Lincoln Continental

2017-2020 Lincoln Continental — Replace Cabin Air Filter

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 30 minutes $18 DIY 2 views

Save $132 by doing it yourself! Shop cost: $150

Quick answer: Replace Cabin Air Filter on a 2017–2020 Lincoln Continental is rated Easy and takes about 30 minutes. You'll need 2 tools for this job, and parts cost about $18. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$18.00
Part Name Part Number Price Buy
Motorcraft Cabin Air Filter Optional — $25.00
FRAM Fresh Breeze Cabin Air Filter Optional CF10119 $20.00
ACDelco Cabin Air Filter — $18.00
K&N Cabin Air Filter Optional VF2050 $35.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Move the passenger seat back

Park the 2017-2020 Continental, set the parking brake, and slide the passenger seat fully back. Empty the glovebox completely. Have the correct single rectangular panel filter ready; keep it sealed until the old one is out.

2

Pop the rear console trim

On the passenger side of the center console, pop the rear trim panel off by pulling gently from its edge — clip-retained. Use a plastic trim tool, not a screwdriver; the Continental's panels mark easily. Set it aside scratch-free.

🔧 Mechanic's note — Ray Delgado

Plastic trim tool, not a screwdriver — I mean it on the Continental. Those soft-touch panels gouge if you look at them wrong, and the marks never come out.

3

Pop the front console trim

Pop off the front console trim panel the same way, working the clips free evenly rather than yanking from one corner. Set it aside with the rear panel — keep track of which is which for reassembly.

4

Pop the trim right of the glove box

Pop off the small trim piece right of the glovebox to expose the fasteners. Use plastic tools and even pressure — the small clips break if forced. With all three trim pieces off, the glovebox screws are accessible.

5

Remove the 7mm glove box screws

Remove the 7mm glovebox screws and pull the box out toward you. Disconnect any attached light wiring carefully — don't let the box hang by the wires. Behind it you'll see the HVAC housing with the filter cover.

6

Release the two filter cover tabs and swap the filter

Release the two cover tabs and pull the cover off. Note the old filter's arrow, then slide it out level. Vacuum the slot. Slide the new filter in arrow-correct, fully seated. Refit the cover until both tabs click.

🔧 Mechanic's note — Tom Becker

Seat that cover until both tabs click — I've chased phantom dash rattles for an hour that were just a filter cover sitting loose. Two clicks or it isn't done.

7

Reassemble in reverse

Reinstall the glovebox (7mm screws, snug), reconnecting the light wiring if detached. Pop the three trim pieces back in reverse order, seating each fully. Run the fan on fresh air at full speed — strong, even airflow, no rattles.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Forgetting to disconnect the vehicle's battery before starting the repair.
  • • Installing the new filter in the wrong orientation, which can reduce its effectiveness.
  • • Neglecting to check for debris or damage in the filter compartment before installing the new filter.