EZCarFix DIY Auto Repair
← Back to Lincoln Continental Guides

2017–2020 Lincoln Continental

2017-2020 Lincoln Continental — Engine Air Filter Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 20-45 minutes $35 DIY

Save $75 by doing it yourself! Shop cost: $110

Quick answer: Engine Air Filter Replacement on a 2017–2020 Lincoln Continental is rated Easy and takes about 20-45 minutes. You'll need 2 tools for this job, and parts cost about $35. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$35.00
Part Name Part Number Price Buy
Engine air filter for 2017-2020 Lincoln Continental; verify engine, housing shape, and VIN fitment DS7Z-9601-A $35.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Prep and locate the air box

Engine off and cool. The housing sits at the front of the engine compartment (CD4 platform, shared with Fusion/MKZ). Ford OE: DS7Z-9601-A. The twin-turbo V6 is sensitive to intake restriction — a clogged filter causes noticeable power loss and turbo lag.

2

Open the air filter housing

Drop-in panel filter — check for clips or screws on your year. Lift the lid only as far as needed, keeping it tethered so it doesn't strain the intake tube. Note the lid orientation for reinstall.

3

Remove the old filter and clean

Lift the filter out. Correct filter: DS7Z-9601-A (also DS7Z9601D); K&N 33-5000. Wipe the airbox with a microfiber cloth, keeping debris out of the intake tube. The turbos spin at 150,000+ RPM — don't extend the interval on a turbo car.

4

Install the new filter

Seat the new filter with the rubber seal fully in the groove, pleats facing the same way as the old one. Run your finger around the whole perimeter — no gaps. An unseated filter lets dirt into the twin-turbo V6.

🔧 Mechanic's note — Ray Delgado

In my experience, Seat the seal in the groove before you swing the lid down — a rolled rubber edge is the most common cause of that post-filter-change whistle.

5

Reseal and verify

Close the lid evenly so the seal compresses equally. Refasten every clip or screw and snug the intake tube clamps. Start the engine and listen: a whistle or hiss means an air leak. Interval: every 15,000–20,000 miles on a turbo car.

🔧 Mechanic's note — Ray Delgado

From my bay, The intake tube clamps loosen with heat cycles — give them a tug check while the lid is open; a loose clamp whistles just like a bad seal.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Confusing the engine filter with the cabin filter
  • • Installing the filter upside down or leaving a corner unseated
  • • Dropping clips, dirt, or shop towels into the intake tract
  • • Over-tightening plastic air-box fasteners
  • • Failing to snug the intake tube clamps.