EZCarFix DIY Auto Repair
← Back to Lincoln Continental Guides

2017–2020 Lincoln Continental

2017-2020 Lincoln Continental — Brake Pad Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 14, 2026

🔧🔧🔧 Advanced 1-3 hours $205 DIY

Save $245 by doing it yourself! Shop cost: $450

Quick answer: Brake Pad Replacement on a 2017–2020 Lincoln Continental is rated Advanced and takes about 1-3 hours. You'll need 3 tools for this job, and parts cost about $205. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$205.00
Part Name Part Number Price Buy
Front or rear brake pad set for 2017-2020 Lincoln Continental; verify axle, brake package, and VIN fitment — $180.00
Replacement pad hardware or wear sensor only if the kit requires it — $25.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm axle, parts, and brake condition

FRONT axle: every trim uses the same front package — 345mm (13.58 in) vented rotors, D1818 pads. Mic the rotors; front minimum around 30.5mm — replace at or below the stamped limit. Check for a rust lip and heat spots.

2

Lift and secure the vehicle

Park level; brake set; chock the rears. Loosen the front lugs on the ground. Raise at factory points; support on stands. A dragging caliper on this quiet sedan often shows as a faint pull, not noise — inspect both sides.

3

Remove the caliper and old pads

Floating caliper on guide pins. Remove the pin bolts; slide the caliper off; hang it with wire. Remove the old pads and hardware. Retract the piston; watch the reservoir. Check the hose — age, not mileage, kills these hoses.

🔧 Mechanic's note — Tom Becker

Age, not mileage, kills these brake hoses — on a Continental of this era, I always look where the flexible hose meets the caliper. Swelling or cracking there is a replace-now item, not a watch item.

4

Install pads and hardware

Wire-brush the bracket's sliding surfaces; clean the pin bores. Grease the pins and pad contact points; fit new clips; slide the pads in. Set caliper back; thread the pin bolts by hand. Grease pad tabs — never the friction face.

5

Torque, pump, and bed in

Refit the wheel; hand-tighten the lugs. Lower; torque to the manual spec star-pattern. Pump the pedal until firm — before the car moves. Verify the fluid level. Bed with moderate stops from about 50 mph, then cool-down driving.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Changing only one pad or mixing pad sets on an axle
  • • Working under a vehicle supported only by a jack
  • • Letting the caliper hang from the brake hose
  • • Forcing a seized piston or ignoring a leaking caliper
  • • Skipping final lug and caliper torque or the bedding procedure