EZCarFix DIY Auto Repair
← Back to Suzuki Swift Guides

1995–2001 Suzuki Swift

1995-2001 Suzuki Swift — Front Brake Pad Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 24, 2026 · Updated Oct 14, 2026

🔧🔧 Moderate 45–75 minutes $217 DIY

Save $148 by doing it yourself! Shop cost: $365

Quick answer: Front Brake Pad Replacement on a 1995–2001 Suzuki Swift is rated Moderate and takes about 45–75 minutes. You'll need 6 tools for this job, and parts cost about $217. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$217.00
Part Name Part Number Price Buy
Front brake pad set (Textar or equivalent) — $50.00
Front brake discs (Brembo or equivalent, if worn) — $148.00
Brake cleaner spray — $10.00
Silicone brake grease — $9.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Raise the Swift and remove the wheel

This matches the 1996 Swift 1.3 (G13BA), 1995–2001 hub range. Loosen the front lug nuts, raise the car, secure it on stands, and remove the wheel. Confirm correct pads — the demo fits Textar pads and Brembo discs.

2

Remove the caliper and old pads

Remove the caliper guide bolts; pivot or lift the caliper off the disc and support it with wire. Slide the pads out and inspect the disc for scoring, measuring thickness with a micrometer.

3

Clean the bracket and inspect the discs

Clean the caliper bracket pad slides with a wire brush and brake cleaner until they shine. Inspect the guide pins and rubber boots, regreasing pins with silicone grease. Replace discs below minimum thickness or deeply scored with Brembo discs.

4

Retract the piston and fit new shims

Open the reservoir cap, then push the caliper piston squarely back with a retractor or C-clamp and an old pad, monitoring the fluid level. Fit the new anti-rattle clips or shims from the Textar set.

🔧 Mechanic's note — Tom Becker

I open the reservoir cap before pushing the piston back — I've fought the pressure on a full reservoir before, and brake fluid ended up all over the strut tower.

5

Install the new pads and refit the caliper

Put silicone grease on the pad backing edges — never the friction face — and slide the pads into the bracket. Refit the caliper, torque the guide bolts to spec, and spin the disc to confirm rotation without dragging.

🔧 Mechanic's note — Tom Becker

I spin the disc by hand after the caliper goes back on — if it drags, the piston isn't seated square or a pad is cocked, and I want to find out now, not at the first stop sign.

6

Reassemble and bed the pads

Reinstall the wheel, lower the Swift, and torque the lug nuts in a star pattern. Pump the brake pedal until firm and check the fluid level. Bed the pads with gentle-to-moderate stops over the first 200 miles of driving.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Cracking the small caliper pistons by compressing them unevenly with a screwdriver instead of a proper tool.
  • • Installing pads without the anti-rattle shims, causing constant brake squeal.
  • • Getting grease on the rotor face, which contaminates the new Textar pads.