← Back to Tesla Model X Guides

2016–2020 Tesla Model X

2016-2020 Tesla Model X - Replace Wiper Blades

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 15 minutes $60 DIY 1 views

Save $40 by doing it yourself! Shop cost: $100

Quick answer: Replace Wiper Blades on a 2016–2020 Tesla Model X is rated Easy and takes about 15 minutes. You'll need 1 tool for this job, and parts cost about $60. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$60.00
Part Name Part Number Price Buy
Driver's Side Wiper Blade (28 inches) 1034389-00-D $30.00
Passenger's Side Wiper Blade (18 inches) 1083742-02-A $30.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Service position (if needed)

The 2016-2020 Tesla Model X requires wiper service mode before the arms can be lifted: Controls > Service > Wiper Service Mode parks the arms upright. Don't force the arms up by hand from the parked position — they tuck under the hood edge and forcing them can damage the arms or cowl trim.

2

Lift the wiper arm

With service mode engaged, lift one Model X wiper arm off the glass until it stays up and slide a folded towel underneath it. Never let a bare spring-loaded arm snap back onto the windshield.

🔧 Mechanic's note — Ray Delgado

I engage Wiper Service Mode on the touchscreen before touching the arms — I've seen someone force a parked Model X arm up and gouge the hood edge.

3

Release the old blade

The Model X uses a pinch-tab connector: squeeze the tabs on the blade connector and slide the blade off the arm. Pull straight along the arm and never twist sideways, which can bend the arm.

🔧 Mechanic's note — Tom Becker

I squeeze the pinch tabs and pull straight along the arm — twisting is how I bent an arm early on, and a bent arm never holds the blade flat.

4

Match the new blade

The 2016-2020 Model X takes a 28-inch driver-side blade and an 18-inch passenger-side blade with the pinch-tab connector — there is no rear wiper on the Model X.

5

Install until it clicks

Slide the new blade onto the arm until the tabs click, then tug gently to confirm it is locked. The 28-inch blade goes on the driver side, the 18-inch on the passenger side.

6

Lower and repeat

Lower each arm gently onto the glass and repeat on the other side, then turn Wiper Service Mode off on the touchscreen so the arms park normally. Top off the washer fluid and run a wash cycle.

🔧 Mechanic's note — Ray Delgado

I turn Wiper Service Mode off on the touchscreen before the test wipe — I've forgotten once, and the arms parked halfway up the windshield like a confused robot.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Not engaging Wiper Service Mode before attempting to replace the blades.
  • • Forcing the wiper arm beyond its intended position, which can damage the arm or windshield.
  • • Using incorrect wiper blade sizes or connectors, leading to improper fitment.