EZCarFix DIY Auto Repair
← Back to BMW 328i Guides

2008–2013 BMW 328i

2008-2013 BMW 328i - Battery Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧 Moderate 30–45 minutes $147 DIY

Save $168 by doing it yourself! Shop cost: $315

Quick answer: Battery Replacement on a 2008–2013 BMW 328i is rated Moderate and takes about 30–45 minutes. You'll need 6 tools for this job, and parts cost about $147. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$147.00
Part Name Part Number Price Buy
Correct group-size battery — $140.00
Terminal cleaner Optional — $8.00
Terminal protectant — $7.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Find the battery behind the right-side trunk trim

Engine off, trunk open. Note the vent hose on the battery's side and the IBS sensor on the negative cable first.

2

Disconnect the negative cable first

Loosen the 10mm nut on the negative terminal and lift the cable straight off the post, taking care not to bend the Intelligent Battery Sensor clamped to the cable end.

🔧 Mechanic's note — Tom Becker

I know that IBS sensor on the negative cable is the car's eyes on the charging system — bend it yanking the cable and you'll get phantom battery warnings. Lift the clamp straight up, and budget for the registration step; the IBS expects it.

3

Disconnect the positive cable

Flip open the red cover over the positive (+) terminal; loosen its 10mm nut and lift the cable off. Keep it clear of metal and the negative post. If the cable end is crusty with white or green corrosion, scrub it clean before reconnecting.

4

Remove the vent hose and hold-down

Pull the vent hose off the battery’s vent elbow — the E90’s trunk battery must vent hydrogen outside the car, and the hose has to go back onto the new battery. Remove the 13mm bolt from the wedge hold-down at the battery’s base and lift the wedge clear. Confirm no other brackets or cables still hold the battery.

5

Swap the batteries

The battery is heavy, so lift with your legs — a carrier strap helps. Lift the old battery straight up and out of the recess.

6

Secure and reconnect

Reinstall the hold-down wedge and tighten its 13mm bolt so the battery cannot shift. Push the vent hose firmly onto the new battery’s vent elbow. Clean both cable ends and the new posts with a battery-terminal brush until the metal shines, then apply corrosion inhibitor spray. Reconnect the positive cable first, tighten it, then reconnect the negative cable last.

7

Start up and finish

Start the engine and check for normal cranking and no new warning lights. Reset the clock and radio presets per the owner’s manual. Remember the under-hood jump-start post with the red cap by the passenger-side firewall for future jump-starts.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Trying to jump-start from the trunk battery when it is dead — use the B+ jump post with the red cap under the hood, on the passenger side near the firewall, instead.
  • • Bending the IBS sensor on the negative cable while wrestling the cable end off the post.
  • • Forgetting to reconnect the vent hose — the trunk-mounted battery must vent hydrogen outside the car.