← Back to Chrysler Concorde Guides

1993–1997 Chrysler Concorde

1993-1997 Chrysler Concorde — Spark Plug Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧🔧 Advanced 1-3 hours $115 DIY

Save $335 by doing it yourself! Shop cost: $450

Quick answer: Spark Plug Replacement on a 1993–1997 Chrysler Concorde is rated Advanced and takes about 1-3 hours. You'll need 5 tools for this job, and parts cost about $115. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$115.00
Part Name Part Number Price Buy
Correct spark plug set for the gasoline/ICE engine in 1993-1997 Chrysler Concorde; verify engine, heat range, gap, and VIN fitment — $115.00
Coil-boot seals or ignition coils only if inspection finds damage Optional — $35.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm engine and plug fitment

You need six. The wide 0.050 gap is specific to these engines — don't substitute plugs pre-gapped at 0.044. Scan for misfire codes first so you know which cylinders to watch.

2

Cool and expose the plugs

Let the engine cool completely; the heads are aluminum. Disconnect the negative battery cable. A 5/8 in plug socket with a rubber insert, a 6-inch extension, and a universal joint are the tools that make the rear bank possible.

3

Remove the wires

Remove ONE wire at a time so the firing order (1-2-3-4-5-6) can't get scrambled — mark each wire's cylinder with tape as it comes off. Twist each boot to break it loose and pull by the boot, never the wire.

4

Remove and install plugs

Remove each old plug with the 5/8 in socket, turning counterclockwise. Compare each old plug's reach and deposits to the new one. Gap every new plug to 0.050 in — verify with a wire gauge even if the box claims pre-gapped. Start each new plug BY HAND for several turns; the rear holes are blind, so spin it in with just the extension until you're sure it's threading straight. Tighten to the manufacturer's spec in your owner's manual. Never use an impact for final seating.

5

Reconnect and verify

Push each wire boot firmly onto its plug until it seats, double-checking your tape marks so every wire is back on its correct cylinder and the routing matches the original — crossed wires cause crossfire on these engines. Reconnect the negative battery cable.

🔧 Mechanic's note — Ray Delgado

My shop rule on these: If the misfire moved cylinders after your work, the new plug is innocent — the wire or coil tower that followed the code is the guilty one. Chasing a fresh plug is the wrong rabbit hole.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Using the wrong plug or assuming a pre-gapped plug needs no verification
  • • Blowing debris into an open cylinder or plug well
  • • Cross-threading a plug or tightening it without a torque wrench
  • • Overusing anti-seize or dielectric grease on the plug threads
  • • Mixing coil connectors or ignoring a misfire after reassembly