Quick answer: Replace PCV Valve on a 2014–2024 Infiniti Q50 is rated Moderate and takes about 1 hour. You'll need 9 tools for this job, and parts cost about $30. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| PCV Valve |
11810-1EA0A |
$25.00 |
|
| PCV valve grommet |
11810-1EA0B |
$5.00 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Cool the engine and locate the PCV valve
Work on a cool engine. Find the PCV valve — usually in a valve-cover grommet, intake manifold port, or integrated into a PCV hose/module. Photograph hose routing before removal. Wear gloves and eye protection.
2
Disconnect the PCV hose
Release any spring clamps or quick-connect fittings and pull the hose from the valve or PCV port. Inspect the hose for cracks, collapse, or oil sludge — replace the hose if damaged.
3
Remove the old PCV valve or module
Pull the valve from its grommet with a gentle twist, or unbolt a PCV module/plate if that is the design. Note orientation and any O-rings. Avoid letting debris fall into the open port.
4
Inspect related parts
Check the grommet for hardening or tears and replace it if damaged. Shake a conventional PCV valve — a stuck rattle or no rattle can indicate failure. Clean sludge from the port with a shop towel; don't push debris into the engine.
🔧 Mechanic's note — Ray Delgado
I know the rattle test is a quick sanity check, not a verdict — a valve can rattle fine and still be gummed shut inside. If the rough idle doesn't clear up, look at the hoses next.
5
Install the new PCV valve
Compare the new valve/module to the old one. Lightly oil the grommet if specified, press or bolt the new unit into place until fully seated, and reconnect the hose until the clamp/connector is secure.
6
Start and verify idle quality
Start the Q50 and confirm a smooth idle with no whistle or vacuum leak sound at the PCV connection. Check for oil seepage. After a short drive, recheck the hose and note whether the rough idle or oil consumption improved.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Not disconnecting the battery before starting the repair
- • Forgetting to replace the gasket, leading to potential leaks
- • Over-tightening the new PCV valve, which can damage the threads