Quick answer: Battery Replacement on a 2020–2024 Lincoln Aviator is rated Easy and takes about 30-90 minutes. You'll need 2 tools for this job, and parts cost about $180. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| Replacement 12-volt battery for 2020-2024 Lincoln Aviator; verify group size, CCA, terminal layout, and VIN fitment |
— |
$180.00 |
|
| Anti-corrosion terminal protectant or felt washers (optional) Optional |
— |
$8.00 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm the Group 94R AGM battery and symptoms
The 2020-2024 Lincoln Aviator uses a BCI Group 94R (DIN H7) AGM 12-volt battery rated around 800 CCA, located in the engine compartment on the driver's side near the fender. AGM construction is required, and the battery is vented to the outside of the vehicle, so you must reconnect the vent tube. Read the group size and CCA from the label on your existing battery or your owner's manual before buying. Confirm the battery is the true problem first: slow cranking, dim lights, a charging warning, or a battery older than four years point to replacement, while a battery that drains overnight may signal a parasitic draw or a failing alternator instead.
2
Park, power down, and protect your settings
Park the Aviator on level ground, shift to Park, set the parking brake, and switch the ignition fully off. Take the key fob away from the vehicle so the modules go to sleep. Open the hood and secure it. Wear safety glasses and gloves, and keep metal tools and jewelry away from the battery posts.
3
Disconnect, unvent, and remove the old battery
Locate the battery on the driver's side of the engine bay and remove any protective cover or bracket over it. Loosen the nut on the negative (-) cable clamp with a 10mm wrench, twist the cable off the post, and tuck it aside where it cannot touch metal. Do the same for the positive (+) cable. Pull the vent tube off the battery's vent fitting, then remove the hold-down clamp bolt at the base of the tray. Lift the heavy Group 94R battery straight up out of the engine bay, keeping it upright.
4
Fit, vent, and reconnect the new battery
Set the new Group 94R/H7 AGM battery into the tray in the same orientation as the old one, matching terminal layout and polarity. Clean any corrosion from the cable clamps with a wire brush, then reconnect the vent tube to the battery's vent fitting so gases escape outside the vehicle. Reinstall the hold-down clamp so the battery cannot shift. Reconnect the positive (+) cable first, then the negative (-), tightening each clamp until the cable cannot twist on the post. Refit the battery cover and confirm the battery sits firmly.
5
Start up and verify the charging system
Start the Aviator and confirm there are no warning lights. If you have a multimeter, expect about 12.6 volts with the engine off and 13.5 to 14.8 volts while running, confirming the alternator charges the new battery. Take a test drive and confirm auto stop-start behaves normally. Stop and recheck your work if the battery feels hot or the charging warning stays lit, and recycle the old battery for the core refund.
🔧 Mechanic's note — Tom Becker
I've seen this exact mistake come through the shop: Stop and recheck your work if the battery feels hot or the charging warning stays lit, and recycle the old battery for the core refund.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Buying by appearance instead of group size, CCA, polarity, and hold-down fit
- • Shorting the positive terminal to the body with a metal tool
- • Lifting the battery by damaged terminals or leaving it unsecured
- • Skipping battery registration, window/clock resets, or charging-system checks when required
- • Assuming a new battery fixes a parasitic draw or charging fault