EZCarFix DIY Auto Repair
← Back to Lincoln Aviator Guides

2020–2024 Lincoln Aviator

2020-2024 Lincoln Aviator - Engine Air Filter Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Nov 6, 2026

🔧 Easy 10-20 minutes $20 DIY

Save $60 by doing it yourself! Shop cost: $80

Quick answer: Engine Air Filter Replacement on a 2020–2024 Lincoln Aviator is rated Easy and takes about 10-20 minutes. You'll need 1 tool for this job, and parts cost about $20. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$20.00
Part Name Part Number Price Buy
Engine air filters (pair) — $20.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Prep and locate the air box

Park on level ground, set the parking brake, engine off (let it cool if just run). The Aviator's 3.0L twin-turbo V6 uses a split intake — two airboxes, one on each side of the engine. Buy a matched pair of panel filters before starting.

2

Open the air filter housing

Press each spring retainer clip off its tab and lift the lid straight up, then repeat on the other box. If a clip resists, wiggle the lid gently — the heat-aged plastic tabs crack easily, and a cracked tab means a whistling, leaky lid.

🔧 Mechanic's note — Tom Becker

In my experience, Work in good light and count the clips as they come off — these spring clips launch into the engine bay if you slip, and the parts store won't have them.

3

Remove the old filter and clean

Lift each old filter out, gasket down, and lay them beside the new pair. Vacuum each box and wipe the sealing lip with a damp rag, keeping debris out of the intake. One filter far dirtier than the other means its lid wasn't sealing.

4

Install the new filter

Seat a fresh filter in each housing with the rubber seal fully in the groove — no gaps, folds, or bunched edges. The two filters are identical, either fits either box; just match the old pleat direction and press each gently flat.

5

Reseal and verify

Refit both lids, snapping every clip fully closed — one that looks shut but isn't latched will whistle at highway speed. Finger-check each lid's seal and confirm both intake tubes are snug, then idle a minute listening for hissing.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Installing the filter upside down or unseated so unfiltered air bypasses the element
  • • Leaving debris in the housing that then gets sucked into the intake
  • • Forcing clips/screws and cracking the plastic air box lid
  • • Reusing a heavily clogged filter instead of replacing it