Quick answer: Brake Pad Replacement on a 2016–2023 Toyota Tacoma is rated Moderate and takes about 1-2 hours. You'll need 4 tools for this job, and parts cost about $85. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| Front or rear brake pad set; verify axle and trim |
— |
$85.00 |
|
| Brake pad abutment clips (new) |
— |
— |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm the axle and prepare the vehicle
Park on level ground, set the parking brake, chock the wheels, and compare the new pad set with the old parts. Identify whether the job is front or rear and follow the vehicle-specific electronic parking-brake service procedure if equipped.
2
Lift safely and remove the wheel
Loosen the lug nuts slightly, raise the 2016-2023 Toyota Tacoma at the approved lift points, place it securely on jack stands, and remove the wheel. Keep the wheel and fasteners organized and support the hub if needed.
3
Inspect the brake assembly
Inspect the 2016-2023 Toyota Tacoma rotor, caliper, hose, dust boots, slide pins, pad wear pattern, and backing hardware. Measure or compare rotor thickness and replace the rotor if it is below minimum thickness, deeply scored, cracked, or badly corroded.
4
Remove the caliper and old pads
Remove the caliper or caliper pins as specified for the 2016-2023 Toyota Tacoma; support the caliper without stressing the hose. Remove the old pads and clips, noting the inner/outer orientation and the location of any wear sensor.
🔧 Mechanic's note — Tom Becker
I pull the Tacoma caliper pins as specified and lay the old pads out in order, noting the wear sensor's spot. It fits exactly one position — guess and I've seen guys redo the whole axle.
5
Service the slides and retract the piston
Clean the 2016-2023 Toyota Tacoma bracket contact points and inspect the slide pins and dust boots. Lubricate only the specified sliding surfaces, then retract the piston with the correct tool while monitoring the master-cylinder reservoir and any electronic parking-brake requirements.
🔧 Mechanic's note — Ray Delgado
On the Tacoma I inspect the slide pins and dust boots first, lube only the specified surfaces, and keep every bit of grease off the pad faces. One fingertip of grease there means a squeal you'll never trace.
6
Install the new pads and reassemble
Install new abutment clips and the 2016-2023 Toyota Tacoma brake pads in the original orientation. Refit the caliper, tighten fasteners to the exact service-manual torque, reinstall the wheel, and torque the lug nuts in a star pattern.
7
Restore hydraulic pressure and bed the pads
Before starting, pump the brake pedal until firm, verify the fluid level and parking-brake operation, then perform a slow controlled test. Bed the brake pads using the parts maker procedure and recheck for noise, pull, leaks, or warning lights.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Ordering the wrong axle, brake package, or pad shape for the vehicle
- • Letting the caliper hang from the brake hose or twisting the hose
- • Compressing an electronic or screw-in rear piston without the required service procedure
- • Installing pads or hardware with grease, rust, or dirt on the friction faces
- • Skipping pedal pumping and the manufacturer-recommended bedding procedure