2018–2024 Volvo XC60

2018-2024 Volvo XC60 — Engine Oil & Filter Change

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧 Moderate 30-60 minutes $57 DIY

Save $63 by doing it yourself! Shop cost: $120

Quick answer: Engine Oil & Filter Change on a 2018–2024 Volvo XC60 is rated Moderate and takes about 30-60 minutes. You'll need 2 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost

$57.00

Oil spec 2.0L turbo I4

Capacity 5.9 qt with filter Viscosity 0W-20 Spec VCC RBS0-2AE

Part Name	Part Number	Price	Buy
Engine Oil (0W-20)	—	$45.00	Amazon
Correct engine oil filter and drain-plug washer for 2018-2024 Volvo XC60	—	$12.00	Amazon

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

Confirm oil specification and make the vehicle safe

The 2.0L VEA (T5/T6) needs 0W-20 synthetic to Volvo spec VCC RBS0-2AE — no generic 5W-30 (causes carbon buildup). Cartridge element in a top-of-engine plastic housing. Check for DIAMOND STAMP (2019+ style) or old style (OE 31410832) before buying.

Warm briefly and protect the work area

Warm until the oil flows freely, then shut off. Remove the fill cap; place a pan under the sump. Have a new aluminum crush washer and a filter cap wrench ready — cheap cup tools slip and crack plastic housings.

Drain the used oil and replace the filter

Drain fully; reinstall the plug with the NEW aluminum crush washer, snug — don't overtighten. Remove the cartridge cap, swap the element, and fit the new O-ring oiled. Refit the cap firmly by hand — impact tightening cracks the housing.

🔧 Mechanic's note — Tom Becker

I've replaced cracked plastic filter housings that were impact-tightened at quick-lube shops. Hand-tight on that cap — it's plastic, and it has to come off again.

Install the correct oil quantity

Add 0W-20 in stages — roughly five and a half quarts total; do NOT pour it all in. No dipstick on the XC60: check the electronic oil gauge after adding most. Keep the fill area clean; refit the cap tightly.

Check level, leaks, and service reminder

Start the engine; check the plug and housing for leaks. Drive 20-30 miles to calibrate the gauge. Park level, wait 30 minutes, read the gauge — add in small amounts (each segment ≈250ml) if low. Reset service reminder; log mileage.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

• Using the wrong viscosity, capacity, or filter
• Working under a vehicle supported only by a jack
• Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
• Over-tightening the filter or drain plug
• Starting the engine before checking the oil level and leaks

Tools You'll Need

Floor jack or ramps and rated jack stands if needed Oil-drain pan, funnel, gloves, and eye protection Socket or wrench for the drain plug and oil-filter tool Calibrated torque wrench and shop towels

⚠️ Safety First!

• Informational DIY. EZ Car Fix is not a shop.
• Work on level ground with the engine off and only safely supported by ramps or rated jack stands; never rely on a jack alone.
• Verify oil viscosity, capacity, filter, and drain-plug washer for the exact engine. Do not mix fluids or overfill.
• Hot oil can burn. Wear gloves and eye protection, keep spills away from tires, and dispose of used oil at an approved collection point.
• Stop if the drain plug, filter housing, pan, or threads are damaged or leaking.