EZCarFix DIY Auto Repair
← Back to Buick Lucerne Guides

2006–2011 Buick Lucerne

2006-2011 Buick Lucerne — Engine Oil & Filter Change

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧 Moderate 30-60 minutes $57 DIY

Save $63 by doing it yourself! Shop cost: $120

Quick answer: Engine Oil & Filter Change on a 2006–2011 Buick Lucerne is rated Moderate and takes about 30-60 minutes. You'll need 2 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$57.00
Oil spec 3.8L V6
Capacity 4.5 qt with filter Viscosity 5W-30 (alt: 0W-30)
Part Name Part Number Price Buy
Engine Oil (5W-30) — $45.00
Correct engine oil filter and drain-plug washer for 2006-2011 Buick Lucerne — $12.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm oil specification and make the vehicle safe

Use 4.5 quarts of 5W-30 (with filter) in the 3.8L V6; spin-on AC Delco PF47 (longer PF61E fits). Gather filter wrench, drain pan, funnel, new drain-plug washer. Sits low, use ramps or jack stands; park level, brake set, wheels chocked.

2

Warm briefly and protect the work area

Warm engine briefly, shut off. Lift the front on ramps or jack stands — never a jack alone. The filter is on the front of the 3800, so set the drain pan under both plug and filter. Remove fill cap.

3

Drain the used oil and replace the filter

Pull the plug; drain fully. Spin off the old filter, keeping it upright — it's full of oil. Confirm the old gasket came off. Oil the new gasket; spin to contact plus three-quarter turn. The longer PF61E fits too.

🔧 Mechanic's note — Tom Becker

I've watched a 3800 pump its whole sump onto a driveway because the old filter's O-ring stuck to the block and the new filter went on over it. Always run a finger across the mounting surface first.

4

Install the correct oil quantity

Reinstall the drain plug with a fresh washer and tighten firmly; wipe the pan clean. Pour in 4.5 quarts of 5W-30 through a funnel, adding the last half-quart slowly while watching the dipstick — this small-sump engine overfills easily.

5

Check level, leaks, and service reminder

Run a minute; check plug and filter for leaks. Off, wait a few minutes, recheck dipstick on level ground, top to full. Log date and mileage; reset the DIC oil-life monitor.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Using the wrong viscosity, capacity, or filter
  • • Working under a vehicle supported only by a jack
  • • Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
  • • Over-tightening the filter or drain plug
  • • Starting the engine without first verifying oil was added