EZCarFix DIY Auto Repair
← Back to Chevrolet Caprice Guides

2011–2017 Chevrolet Caprice

2011-2017 Chevrolet Caprice — Cabin Air Filter Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 25-35 minutes $28 DIY

Save $72 by doing it yourself! Shop cost: $100

Quick answer: Cabin Air Filter Replacement on a 2011–2017 Chevrolet Caprice is rated Easy and takes about 25-35 minutes. You'll need 2 tools for this job, and parts cost about $28. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$28.00
Part Name Part Number Price Buy
Cabin air filter for 2011-2017 Chevrolet Caprice; verify arrows, size, and VIN/trim fitment — $28.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Park and open the hood

Park on level ground with the ignition off and pop the hood. The Caprice's cabin filter is not behind the glove box. It lives under the hood on the passenger side, beneath the air-inlet grille panel at the base of the windshield.

2

Remove the wiper arms

Lift each wiper arm away from the windshield and remove the arm from its splined post. A small wiper-arm puller helps, but do not hammer on them. Remember: the wipers must come off before the grille panel can, because the panel tucks under them.

3

Pull off the rear hood seal

Pull it straight up and off its channel and set it aside. It is a friction fit, no clips, but work along its length so you do not tear the rubber.

4

Free the passenger-side air inlet grille

Release them, then pull the panel upward and inward toward the engine to disengage the retainers along its rear edge. Lift the whole panel off and set it somewhere it will not get stepped on.

5

Pull out the old filter

The dirty filter lifts out by pushing it downward and pulling it out toward you. Note which way its airflow arrow points before you remove it. That debris is what clogs the drain and makes the vents smell musty.

6

Drop in the new filter

Set the new filter into the tray in the same orientation as the old one, matching the airflow arrow. Press it down so it seats flat and square in the housing. Make sure the edges sit fully inside the tray lip all the way around.

7

Refit the hood seal and wipers and test the HVAC

Press the rear hood seal back into its channel along the full length. Reinstall the wiper arms on their posts aligned with your tape marks, snug the nuts, close the hood, and run the HVAC to confirm strong airflow.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Skipping the tape marks and reinstalling the wiper arms out of position, so they clash or park crooked.
  • • Breaking the grille-panel retainers by prying the panel straight up instead of pulling up and inward.
  • • Seating the new filter crooked in the tray, which lets dusty air bypass it entirely.
  • • Forgetting to clear leaves and grit from the cowl tray, so the new filter clogs fast.