Quick answer: Engine Oil & Filter Change on a 2011–2017 Chevrolet Caprice is rated Moderate and takes about 30-60 minutes. You'll need 3 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.
Oil spec
6.0L V8 (L77)
Capacity 8.0 qt with filter Viscosity 5W-30 (alt: 0W-30)
| Part Name |
Part Number |
Price |
Buy |
| Engine Oil (5W-30) |
— |
$45.00 |
|
| Correct engine oil filter and drain-plug washer for 2011-2017 Chevrolet Caprice |
— |
$12.00 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm oil specification and make the vehicle safe
Gather 8.0 quarts of full-synthetic 5W-30, an ACDelco PF48/PF48E spin-on filter, a 9-quart drain pan, funnel, gloves, a 15mm socket, and a filter wrench. Park level, chock the rear wheels, and raise the front onto jack stands or ramps.
🔧 Mechanic's note — Tom Becker
Eight quarts looks like a lot on paper, but that L77 sump is deep — I buy a 5-quart jug plus three single quarts and have exactly what I need.
2
Warm briefly and protect the work area
Idle 2-3 minutes so the oil drains fast, then shut off before the exhaust gets hot. Remove the filler cap and lift the dipstick to vent the crankcase. Position the drain pan under the pan and spread cardboard for drips.
3
Drain the used oil and replace the filter
Crack the drain plug on the oil pan (a 15mm socket fits the L77's M12 plug — confirm fit) and spin it out by hand over the large drain pan; eight quarts comes out fast. The spin-on filter (ACDelco PF48/PF48E type) screws onto the driver's side of the block — reach it from below with a filter wrench and spin it off slowly, keeping it upright. Wipe the mounting boss and confirm the old gasket came away with the filter. Pre-fill the new filter halfway, oil its gasket, and tighten to seat plus three-quarter turn. Thread the plug back in by hand and snug it firmly — your owner's manual lists the exact torque.
🔧 Mechanic's note — Ray Delgado
I run a finger around the boss after every filter removal — that old filter gasket sticking to the block is the classic double-gasket blowout, or you'll pump eight quarts onto the driveway at startup.
4
Install the correct oil quantity
Set a funnel in the filler neck and pour in 8.0 quarts of full-synthetic 5W-30. Pour slowly and watch the markings — adding a final half-quart later beats draining an overfill.
5
Check level, leaks, and service reminder
Idle one minute, watching the plug and filter area for leaks, then shut off and wait two minutes. Top up if below the full mark. Reset the oil-life monitor through the driver information center; recycle the used oil.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Using the wrong viscosity, capacity, or filter
- • Working under a vehicle supported only by a jack
- • Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
- • Over-tightening the filter or drain plug
- • Starting the engine before checking the oil level and leaks