EZCarFix DIY Auto Repair
← Back to Chevrolet Caprice Guides

2011–2017 Chevrolet Caprice

2011-2017 Chevrolet Caprice — Tire Pressure & Rotation

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 14, 2026

🔧🔧 Moderate 45-75 minutes $10 DIY

Save $70 by doing it yourself! Shop cost: $80

Quick answer: Tire Pressure & Rotation on a 2011–2017 Chevrolet Caprice is rated Moderate and takes about 45-75 minutes. You'll need 3 tools for this job, and parts cost about $10. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$10.00
Part Name Part Number Price Buy
Valve-stem caps or replacement TPMS service parts only if inspection requires them — $10.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Check and set cold tire pressure

Check pressures cold — before driving or three hours after parking. Use the door-jamb Tire and Loading Information sticker, not the sidewall maximum. Adjust every tire to the sticker spec, refit caps finger-tight, and check the spare — it loses air even out of rotation.

🔧 Mechanic's note — Ray Delgado

Gas-station air gauges get dropped and abused — I've seen them read 5 psi off. A ten-dollar stick gauge in the glovebox beats them every time.

2

Inspect tread and sidewalls for wear or damage

Measure tread depth — 2/32 is the legal minimum; near that means replace, not rotate. Centers worn smooth mean overinflation, both edges worn mean underinflation, cupping or one-sided wear means alignment or suspension trouble rotation can't fix. Check sidewalls for cuts, bulges, and cracking.

3

Set up and lift the Caprice safely

Set the parking brake and chock opposite wheels. Crack each lug nut a half-turn on the ground. Jack at the manual's lift points, lower onto rated jack stands — never work under a jack alone. Remove the wheels, noting which corner each tire came from.

4

Rotate the tires in the RWD pattern

Use the rearward-cross pattern for same-size, non-directional tires: rears forward on the same side, fronts to the opposite rear. Directional tires — with a rotation arrow — go front-to-back on the same side only, never across. Hand-thread the lug nuts, snug in a star sequence.

5

Torque the lugs, lower, and relearn the TPMS

Lower the car, then torque the lug nuts in a star pattern to the owner's-manual spec. Relearn the TPMS: parking brake set, ignition on (engine off), hold the fob's lock+unlock buttons about five seconds until the horn chirps twice. Recheck pressures against the sticker afterward.

🔧 Mechanic's note — Ray Delgado

In my experience, Relearn order is left front, right front, right rear, left rear: add or release air at each corner until the horn chirps; a double chirp confirms the relearn. Mix up the order and the dash shows each pressure under the wrong corner.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Inflating to the sidewall maximum instead of placard PSI
  • • Using the wrong rotation pattern for directional or staggered tires
  • • Relying on an impact gun without final torque verification
  • • Assuming a TPMS light clears when a tire or sensor is damaged