EZCarFix DIY Auto Repair
← Back to Chevrolet HHR Guides

2006–2011 Chevrolet HHR

2006-2011 Chevrolet HHR — Cabin Air Filter Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 15–25 minutes $28 DIY

Save $72 by doing it yourself! Shop cost: $100

Quick answer: Cabin Air Filter Replacement on a 2006–2011 Chevrolet HHR is rated Easy and takes about 15–25 minutes. You'll need 2 tools for this job, and parts cost about $28. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$28.00
Part Name Part Number Price Buy
Cabin air filter for 2006-2011 Chevrolet HHR; verify arrows, size, and VIN/trim fitment — $28.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Empty and open the glove box

Park, ignition off, and open the glove box. The HHR's cabin filter sits behind the glove box — empty the compartment first, since the box swings down and the 7mm damper-arm work needs a clear, empty box.

2

Remove the damper arm bolt

On the right side of the open glove box you'll see the hinge arm with a small bolt through it. Loosen the 7mm bolt with a socket and finish by hand, then pull the arm free of the hinge.

🔧 Mechanic's note — Tom Becker

I always thread that little 7mm bolt by hand first — drop it behind the dash and you're fishing for ten minutes with a magnet.

3

Drop the glove box down

With the arm disconnected, squeeze the glove box sides inward and pull toward you to release the two tabs. The box swings down on its hinges — if squeezing doesn't work, reach behind and push the tabs outward.

4

Open the three-clip access panel

You'll now see the access panel with three clips — A, B, and C — along its top edge. Pull each clip straight down to release; don't pry sideways. With all three released, the panel opens downward, exposing the filter.

🔧 Mechanic's note — Tom Becker

Those three clips love to snap if you pry sideways — I've broken plenty. Straight down, firm and slow, and the panel pops right off.

5

Slide out the old filter

Slide the old filter out and note its orientation — the replacement goes in the same way. Check the housing for leaves and debris and clean it with a rag or vacuum before the new filter goes in.

6

Install the new filter and close the panel

Slide the new filter in, same orientation as the old one, fully home and flat. Swing the access panel back up and press it closed until all three clips — A, B, C — click into place.

7

Reattach the arm and test

Swing the glove box up past the two tabs until it seats, then reconnect the damper arm. Thread the 7mm bolt by hand, then snug it — firm, not gorilla-tight. Close the box and run the fan to confirm airflow.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Dropping the small 7mm damper bolt into the dash — thread it back in by hand first on reassembly.
  • • Pulling the access panel sideways instead of pulling the three clips straight down, which snaps them off.
  • • Squeezing only one side of the glove box and cracking a stop tab.
  • • Pulling the old filter out without noting its orientation, then guessing on the reinstall.