← Back to Chevrolet HHR Guides

2006–2011 Chevrolet HHR

2006-2011 Chevrolet HHR — Engine Air Filter Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 20–25 minutes $35 DIY

Save $75 by doing it yourself! Shop cost: $110

Quick answer: Engine Air Filter Replacement on a 2006–2011 Chevrolet HHR is rated Easy and takes about 20–25 minutes. You'll need 2 tools for this job, and parts cost about $35. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$35.00
Part Name Part Number Price Buy
Engine air filter for 2006-2011 Chevrolet HHR; verify engine, housing shape, and VIN fitment — $35.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Know where the filter lives on an HHR

Park on level ground, shut the engine off, and let the 2.2L or 2.4L Ecotec cool. The HHR has no separate side airbox — the big plastic engine cover doubles as the filter housing, so the whole cover comes off.

2

Unplug the MAF sensor connector

Find the mass airflow sensor connector just under the front-center edge of the engine cover. Wiggle it slightly and pull straight out to disconnect. Never touch the delicate sensor element — handle the connector body only.

3

Loosen the intake hose clamps

Loosen — don't remove — the large hose clamps on the passenger-side intake hose and the center hose attached to the cover. The screw heads can face away from you and access is tight, so work by feel.

4

Pull the cover off its rubber grommets

The housing snaps onto three rubber grommets — no bolts. Give the front passenger corner a firm, steady pull to pop it free, then free the other two the same way. Lift the cover out and carry it to a clean work surface.

🔧 Mechanic's note — Tom Becker

The first time I did an HHR I yanked that cover straight up and cracked a grommet seat. Rock it corner by corner — the grommets tear if you get greedy.

5

Flip the cover and open the filter cavity

Turn the cover over. Back out the seven captive Torx screws around the inner panel — they loosen but stay in the panel, so you can't lose them. Lift the inner cover off to expose the old filter.

6

Swap the filter and clean the cavity

Lift out the old filter and wipe the cavity clean of dust and grit. Set the new filter in exactly the same orientation, sealing edge flat against the cover. Check it lies evenly before the inner panel goes back on.

7

Reassemble, reseat, and reconnect

Refit the inner panel and snug the seven Torx screws evenly — snug only, they thread into plastic. Press the cover straight back onto its three grommets until each seats, reposition the hoses, snug the clamps, and plug the MAF connector back in.

🔧 Mechanic's note — Tom Becker

In my experience, Plug that MAF connector back in before you start the engine. Running it unplugged sets a code and a check-engine light you'll need a scanner to clear.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Yanking the cover before the hose clamps are loosened
  • • Forgetting to unplug the MAF connector before pulling the cover
  • • Overtightening the seven screws into the plastic cover
  • • Not pressing all three grommets fully back onto their posts