EZCarFix DIY Auto Repair
← Back to Chevrolet HHR Guides

2006–2011 Chevrolet HHR

2006-2011 Chevrolet HHR — Brake Pad Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 14, 2026

🔧🔧🔧 Advanced 1-3 hours $205 DIY

Save $245 by doing it yourself! Shop cost: $450

Quick answer: Brake Pad Replacement on a 2006–2011 Chevrolet HHR is rated Advanced and takes about 1-3 hours. You'll need 4 tools for this job, and parts cost about $205. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$205.00
Part Name Part Number Price Buy
Front or rear brake pad set for 2006-2011 Chevrolet HHR; verify axle, brake package, and VIN fitment — $180.00
Replacement pad hardware or wear sensor only if the kit requires it — $25.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm axle, parts, and brake condition

FRONT axle only. HHR: single-piston floating calipers — 53.85 mm piston, 276 mm vented rotor. Buy front pads for your trim, new stainless retainers, brake cleaner, silicone grease. Reservoir near MAX? Siphon out. Retract with a C-clamp against old pad.

2

Lift and secure the vehicle

Park level; chock the rear wheels; brake set. Break the lug nuts loose on the ground; jack the front at the factory points; settle onto rated stands — never under a jack alone. Remove the wheel.

3

Remove the caliper and old pads

Remove the two guide-pin bolts (9/16 in) — hold each pin's flats with a second wrench. Slide the caliper off; hang it with wire hook. Pull the old pads; inspect the rotor face, pins and boots, and piston dust seal.

🔧 Mechanic's note — Tom Becker

I hold the guide pin flats with a second wrench — if the pin spins with the bolt, you'll fight it forever. That's a lesson I learned once.

4

Install pads and hardware

Wear-sensor pad INBOARD, leading edge at the bottom. Clean the lands; fit the new retainers with a whisper-thin coat of lube; drop in the pads. Retract piston with a C-clamp through an old pad. Keep grease off the friction faces.

5

Torque, pump, and bed in

Torque the guide-pin bolts to spec (bracket bolts: 15 mm socket). Refit the wheel; lower; tighten the lugs in a star pattern. Pump the pedal until firm. Bed with moderate stops; avoid hard stops for the first couple hundred miles.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Changing only one pad or mixing pad sets on an axle
  • • Working under a vehicle supported only by a jack
  • • Letting the caliper hang from the brake hose
  • • Forcing a seized piston or ignoring a leaking caliper
  • • Skipping final lug and caliper torque or the bedding procedure