Quick answer: Battery Replacement on a 2006–2011 Chevrolet HHR is rated Easy and takes about 30-90 minutes. You'll need 2 tools for this job, and parts cost about $180. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| Replacement 12-volt battery for 2006-2011 Chevrolet HHR; verify group size, CCA, terminal layout, and VIN fitment |
— |
$180.00 |
|
| Anti-corrosion terminal protectant or felt washers (optional) Optional |
— |
$8.00 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Know where the HHR battery hides
The HHR's battery isn't under the hood — it's under the cargo floor; the hood has jump terminals. Usually a Group 96R or 42 (T5); read your label. Cabin-mounted means the vent tube must be reconnected — non-negotiable for safety.
🔧 Mechanic's note — Tom Becker
Most people tear the hood open first — I've watched them hunt under there for ten minutes before realizing the battery is under the cargo floor. Check the rear well first.
2
Access the battery and make it safe
Park level, ignition off. Lift the cargo floor panel to expose the battery. Wear safety glasses and gloves. A memory saver preserves presets; without one, have the security code handy. Tools: 10 mm wrench, hold-down socket, wire brush, terminal protector.
3
Disconnect the old battery, negative first
Loosen the negative clamp with the 10 mm wrench and twist it off, tucking it aside. Remove the positive clamp. Keep the wrench from bridging the posts. Note the vent hose — it must be reconnected to the new battery.
🔧 Mechanic's note — Tom Becker
In my experience, The vent tube is the part that gets people. A battery in the passenger area venting hydrogen with no tube routed outside is a real hazard — seat it before you celebrate.
4
Release the hold-down and install the new battery
Unbolt the hold-down and lift the old battery out — roughly 35-40 lbs from a kneel, so get a grip. Scrub the well with baking-soda solution. Set the new battery in, reconnect the vent hose, and bolt the hold-down down.
5
Reconnect, verify venting, and test
Reconnect positive first, then negative, snugging each so it can't twist. Confirm the vent hose is attached and routed out of the cabin. Start the HHR: brisk crank, no battery light. Check voltage at the jump terminals: 13.5-14.5 volts running.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Buying by appearance instead of group size, CCA, polarity, and hold-down fit
- • Shorting the positive terminal to the body with a metal tool
- • Lifting the battery by damaged terminals or leaving it unsecured
- • Skipping battery registration, window/clock resets, or charging-system checks when required
- • Assuming a new battery fixes a parasitic draw or charging fault