EZCarFix DIY Auto Repair
← Back to Fiat 500X Guides

2016–2021 Fiat 500X

2016-2021 Fiat 500X — Engine Oil & Filter Change

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧 Moderate 30-60 minutes $57 DIY

Save $63 by doing it yourself! Shop cost: $120

Quick answer: Engine Oil & Filter Change on a 2016–2021 Fiat 500X is rated Moderate and takes about 30-60 minutes. You'll need 5 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$57.00
Oil spec 2.4L I-4
Capacity 5.5 qt with filter Viscosity 0W-20 Spec MS-6395
Part Name Part Number Price Buy
Engine Oil (0W-20) — $45.00
Correct engine oil filter and drain-plug washer for 2016-2021 Fiat 500X — $12.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm oil specification and make the vehicle safe

The 500X's 2.4L Tigershark is the same engine as the Jeep Renegade's, which takes 5.5 US quarts of 0W-20 meeting Chrysler MS-6395 — confirm your exact capacity in the owner's manual. The drain plug takes a 13mm socket.

2

Warm briefly and protect the work area

Remove the 500X's skid plate — 10mm and 13mm bolts plus T-30 Torx screws — supporting it with one hand on the last bolt. Keep the T-30 screws separate from the bolts; they strip easily if forced into the wrong hole.

3

Drain the oil and remove the old filter

Remove the 13mm drain plug and drain the sump. Spin off the old spin-on filter — keep the pan under it, and verify the old gasket came off with the filter.

🔧 Mechanic's note — Ray Delgado

I keep the pan under the 500X's spin-on the whole time it's off — the filter drains down the block face and onto whatever's below it. Position the pan once, right, and you won't be chasing oil across the garage floor.

4

Install the correct oil quantity

Spin on the new spin-on filter and tighten it snug by hand. Pour in 5.5 quarts of 0W-20, adding the last quart slowly — double-check against your manual's capacity. Refit the oil cap and skid plate with its bolts and T-30 screws.

🔧 Mechanic's note — Ray Delgado

Five and a half quarts in the 500X, last quart slow — and I check the manual's capacity figure against the guide before I commit. Half a quart over in a 2.4L is a problem; on the mark is the whole game.

5

Check level, leaks, and service reminder

Idle the engine 30-60 seconds and check for leaks; shut off, wait a few minutes, and confirm the dipstick reads full. Reset the indicator per the manual — ignition ON without starting, then the gas pedal pressed slowly three times within 10 seconds.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Using the wrong viscosity, capacity, or filter
  • • Working under a vehicle supported only by a jack
  • • Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
  • • Over-tightening the filter or drain plug
  • • Starting the engine without first verifying oil was added