Quick answer: Engine Oil & Filter Change on a 2011–2022 Hyundai Accent is rated Moderate and takes about 30-60 minutes. You'll need 2 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.
Oil spec
1.6L I4 GDI (G4FD, 2011-2016)
Capacity 3.5 qt with filter Viscosity 5W-20 (alt: 5W-30) Spec API SM / ILSAC GF-4
| Part Name |
Part Number |
Price |
Buy |
| Engine Oil (5W-20) |
— |
$45.00 |
|
| Correct engine oil filter and drain-plug washer for 2011-2022 Hyundai Accent |
— |
$12.00 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm oil specification and make the vehicle safe
2012-2019 Accent 1.6L: 3.5 quarts of 5W-20. Spin-on under engine — the 2020 switched to cartridge, so this guide covers 2012-2019 only. Have filter wrench, drain pan, funnel, new washer. Park level, brake set, chocked; use ramps or stands.
🔧 Mechanic's note — Tom Becker
This guide covers 2012-2019 only — the 2020 redesign switched the 1.6L to a cartridge housing, a completely different job. I always verify my year before I order parts.
2
Warm briefly and protect the work area
Warm a few minutes, then shut off. Raise the front on ramps or stands — never a jack alone. Locate the drain plug and spin-on; remove the fill cap. A small funnel helps at the tight fill neck.
3
Drain the used oil and replace the filter
Drain fully. Break old spin-on free with wrench; spin off by hand, keeping upright. Check old seal came off — not stuck to block. Wipe mounting surface, oil new gasket, spin to gasket contact plus three-quarter turn.
4
Install the correct oil quantity
Refit the plug with a fresh washer. Pour in 3.5 quarts of 5W-20, checking the dipstick over the last half quart. The low-to-full range is only about a quart — pour carefully.
5
Check level, leaks, and service reminder
Run a minute; check for leaks, then shut off. Wait a few minutes, recheck the dipstick, adjust to the full mark without overfilling. Record the date and mileage; reset the maintenance reminder if equipped.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Using the wrong viscosity, capacity, or filter
- • Working under a vehicle supported only by a jack
- • Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
- • Over-tightening the filter or drain plug
- • Starting the engine without first verifying oil was added
