Quick answer: Engine Oil & Filter Change on a 2016–2023 Mercedes-Benz Metris is rated Moderate and takes about 30-60 minutes. You'll need 2 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.
Oil spec
2.0L turbo I4 (M274)
Capacity 8.1 qt with filter Viscosity 5W-40 Spec MB 229.5
| Part Name |
Part Number |
Price |
Buy |
| Engine Oil (5W-40) |
— |
$45.00 |
|
| Correct engine oil filter and drain-plug washer for 2016-2023 Mercedes-Benz Metris |
— |
$12.00 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm oil specification and make the vehicle safe
M274 2.0L turbo: 8.1 quarts (7.7 liters) with filter — buy enough. Spec: 5W-40 meeting MB 229.5; confirm the approval on the bottle. Interval 10,000 miles/12 months. Park level, brake set. Gather cartridge element with new O-ring, washer, 9-quart-plus pan.
🔧 Mechanic's note — Ray Delgado
Eight quarts in a four-cylinder catches everyone off guard — I've seen the job stopped halfway for an oil run. Buy two 5-quart jugs up front; the leftover covers top-ups for the year.
2
Warm briefly and protect the work area
Idle a few minutes, off; pull the filler cap. It sits high — the plug is usually reachable without lifting. Slide the large pan under the oil pan; 8+ quarts overflows an undersized pan.
3
Drain the used oil and replace the cartridge filter
Pull the plug; drain fully. Refit with a new washer, tighten firmly. The cartridge housing is top-side: loosen the cap, lift out the old element. Swap the cartridge; seat the new O-ring oiled in the cap groove — don't overtighten the plastic.
4
Install the correct oil quantity
Pour 8.1 quarts (7.7L) MB 229.5 5W-40 — 7 quarts first, wait a few minutes, dipstick, top up gradually. Pour slowly; the filler neck gurgles and splashes if rushed. Refit the cap.
5
Check level, leaks, and service reminder
Start, idle a minute; oil-pressure warning must stay off. Off, wait several minutes, recheck dipstick on level ground, adjust to full. Inspect plug and housing for leaks. Reset the reminder via the cluster; note date and mileage.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Using the wrong viscosity, capacity, or filter
- • Working under a vehicle supported only by a jack
- • Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
- • Over-tightening the filter or drain plug
- • Starting the engine without first verifying oil was added
