Quick answer: Engine Oil & Filter Change on a 2015–2024 Porsche Macan is rated Moderate and takes about 30-60 minutes. You'll need 3 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.
Oil spec
2.0L turbo I-4
Capacity 5.5 qt with filter Viscosity 0W-20 (alt: 5W-30) Spec Porsche C20
| Part Name |
Part Number |
Price |
Buy |
| Engine Oil (0W-20) |
— |
$45.00 |
|
| Correct engine oil filter and drain-plug washer for 2015-2024 Porsche Macan S |
— |
$12.00 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm your Macan's engine and oil spec
The Macan's oil spec changed by year — check yours before buying oil. The 2.0T takes 4.9 quarts of 5W-30 meeting Porsche C30 (2017-2018) or 5.5 quarts (5.2L) of 0W-20 meeting Porsche C20 (2019+). Mann HU925/4Y for the 2.0T).
🔧 Mechanic's note — Ray Delgado
C30 for 2017-2018, C20 for 2019-up — the approval letters matter more than the viscosity number. I've seen C20 oil poured into C30 cars because "0W-20 is 0W-20."
2
Warm up and expose the filter housing
Run the engine just long enough to warm the oil, then switch off and open the hood. Remove the plastic engine cover to expose the cartridge filter housing on top. The Macan sits high enough to reach everything without lifting it — otherwise use ramps or rated jack stands, never a jack alone.
3
Remove the old oil
If extracting: feed the extractor tube down the dipstick tube to the bottom of the pan and pump the old oil out. Remove the oil fill cap to vent the crankcase while it drains.
4
Swap the cartridge filter
Loosen the filter housing cap with a 32mm socket and lift it out with the old cartridge attached. Pull the old element off, remove the old O-rings, and fit the new O-rings with a light film of fresh oil. Press the new cartridge onto the cap until it seats, then thread the cap back in and tighten to spec — snug, since the housing is plastic. Wipe the housing area clean.
🔧 Mechanic's note — Tom Becker
In my experience, If you extract through the dipstick tube, you never touch the drain plug — it's the cleanest oil change you'll ever do. Just make sure the extractor tube reaches the very bottom of the pan.
5
Refill to spec and check the electronic level
The Macan has no dipstick — start the engine, idle a minute, switch off, and check the oil level in the instrument cluster menu; add small amounts until it reads correctly, never overfilling.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Using the wrong viscosity, capacity, or filter
- • Working under a vehicle supported only by a jack
- • Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
- • Over-tightening the filter or drain plug
- • Starting the engine before checking the oil level and leaks
